National Instruments PCI-6154 Quick start guide

NOTE TO USERS
Installing EMI Suppression
Ferrites for the NI PCI-6154
To ensure the specified EMC performance of the NI PCI-6154, you must install two snap-on
ferrite cores, included with your device, onto each end of the I/O cable you use to connect to the
NI PCI-6154 device.
The snap-on ferrite cores must be installed on the I/O cable as close to each end connector as
possible and securely locked, as shown in the following figure.
You can order additional EMI suppression ferrites from NI (part number 711627-01).
1 Ferrite (NI Part Number 711627-01)
2 NI DB37M-DB37F-EP I/O Cable (NI Part Number 193737-01)
1
2

© 2014 National Instruments. All rights reserved.
376251A-01 Apr14
Refer to the NI Trademarks and Logo Guidelines at ni.com/trademarks for more information on National Instruments trademarks. Other
product and company names mentioned herein are trademarks or trade names of their respective companies. For patents covering National
Instruments products/technology, refer to the appropriate location: Help»Patents in your software, the patents.txt file on your media, or the
National Instruments Patents Notice at ni.com/patents. You can find information about end-user license agreements (EULAs) and third-party
legal notices in the readme file for your NI product. Refer to the Export Compliance Information at ni.com/legal/export-compliance
for the National Instruments global trade compliance policy and how to obtain relevant HTS codes, ECCNs, and other import/export data. NI MAKES
NO EXPRESS OR IMPLIED WARRANTIES AS TO THE ACCURACY OF THE INFORMATION CONTAINED HEREIN AND SHALL NOT BE LIABLE FOR
ANY ERRORS. U.S. Government Customers: The data contained in this manual was developed at private expense and is subject to the applicable
limited rights and restricted data rights as set forth in FAR 52.227-14s, DFAR 252.227-7014, and DFAR 252.227-7015.