For Indoor or Outdoor Display
Retain carton for stora e purposes
ASSEMBLY:
Pl ce the tree b se on sturdy surf ce
nd insert the center pole of the tree into
the center opening of the b se. Push the
tree in until it is firmly se ted.
Taller trees will h ve n ddition l tree
section. Insert the center pole of the lower
tree section into the center opening of the
b se nd push down until firmly se ted;
tighten thumb screw if equipped. Insert
upper section center pole into lower
section center pole nd push down until
firmly se ted.
The light string cords from sep r te tree
sections h ve to be connected. Plug the
light string cord from the top section
into the end (fem le) connector of
the bottom section (Fig. 1).
SHAPING:
The tree is shipped from the f ctory
with the tips of e ch br nch
compressed to the center. Working
your w y up from the bottom, gently
lower e ch br nch from its upright
setting by gr sping the br nch nd
pulling it downw rd (Fig. 2).
E ch br nch must the be sh ped to
n tur l position by spre ding out
the left nd right tips w y from the
center tip. Continue to lower nd
sh pe br nches in the s me
m nner s you work your w y up
the tree.
STORAGE:
Br nch tips should be c refully
pressed b ck tow rd center when tree is
dis ssembled for stor ge. Store in the
origin l c rton in cool, dry loc tion,
protected from sunlight.
Fi . 1
Fi . 2
1. Unplug light string from power source.
2. Pull up on the Bulb Lock (if equipped)
unl tching the bulb from the bulb socket.
Gently pull the bulb str ight out (Figure 1).
3. Before inserting the new bulb
into socket, m ke sure th t the
two wires on either side of the
the bulb b se re str ight up
nd flush with the b se
(di gr m t right).
4. C refully insert new bulb into socket nd
push down Bulb Lock (if equipped) until it
sn ps into pl ce (Figure 2).
1. Unplug light string from power source.
2. Fuses re loc ted in light string plug. Slide
the fuse ccess cover w y from cord side
(in direction of rrow, Figure 1) exposing
fuses.
3. Remove fuses from comp rtment nd
ex mine. Repl ce burnt out fuse with
new one.
4. Close fuse comp rtment by sliding ccess
cover b ck in tow rds cord side of plug
(Figure 2).
Fig. 1
Fig. 2
Fig. 1
Fig. 2
BULB REPLACEMENT INSTRUCTIONS
FUSE REPLACEMENT INSTRUCTIONS
