NCR 7606-K354 Manual

7606‐K354
PCIeVideoCard
KitInstructions
IssueA

Revision Record
Issue Date Remarks
A Jul 2014 First Issue

1
Introduction
ThiskitprovidesaPCIeVideoCardandCageforthe7606.
Note: TheRiserCardandCagemustbepresentintheterminal(PCI/PCIeRiserCard
(7606‐K150).
Kit Contents
33370
EMI Gasket
497-0504412
Rubber Bumper
006+-86923626
PCI-Express Gt610 Graphics Card
497-0504113

2
Installation Procedures
Caution: StaticElectricityDischargemaypermanentlydamageyoursystem.
Dischargeanystaticelectricitybuildupinyourbodybytouchingyourcomputerʹs
caseforafewseconds.Avoidanycontactwithinternalpartsandhandlecardsonly
bytheirexternaledges.
1. TurnOffthepowertotheterminalanddisconnectanyperipheraldevices.
2. Unplugtheterminalʹspowercord.
3. 2.RemovetheFrontCover.
a. TurntheKeylocktotheunlockedposition.
b. PullthetopedgeoftheFrontCoverawayfromthechassisandremovethe
cover.
4. RemovetheTopCover.
a. Loosenthethumbscrews(2)thatsecuretheTopCover.
30629
30634
Thumbscrews

3
b. Slidethecovertowardtherearoftheterminaltoremoveit.
5. LoosenthethumbscrewonthePCICageandthendisconnecttheRiserCardfrom
themotherboard.
30827
PCI Cage
Riser Card

4
6. RemovetheadhesivebackingfromthebottomoftheEMIGasketandinstallitin
thePCICage.
7. RemovethepaperbackingfromtheRubberBumperandadhereittothebackof
theRiserCard.
33372
EMI Gasket
(Adhesive on bottom side)
33373

5
8. ConnectthePCIVideoCardtotheRiserCard.
9. InstallthePCICageandRiserCardassemblyintheterminal.
10. Securetheassemblywiththethumbscrew.
11. ReplacetheTopCover.
12. ReplacetheFrontBezel.
33369
PCIe Video Card
30827
PCI Cage
Riser Card

6
BIOS Settings
EnterBIOSSetupandmakethefollowingchanges.
1. Setthemotherboardvideoasprimary.
Chipset>>Northbridge>>Initial Graphic Adapter
SelectIGDastheprimary.
2. Enablemultiplemonitors.
Chipset>>Northbridge>>IGD Multi-Monitor
SettoEnabled
3. SavechangesandexitBIOSSetup.
Driver Installation
TheVideoCardrequiresaspecialdriver.InstallthedriverfromtheCDincludedin
thekitcontents.