NDT StringScan II User manual

Lightweight Manual X-Y Scanner
Scanner Set Up
5542 Buckingham Drive
Huntington Beach CA, 92649
Phone: [phone] Fax: [phone]
Email: [e-mail]
www.ndtsystems.com
StringScan II

NDT Systems
StringScan II Setup
StringScan II component parts Remove the transducer holder from its ZERO park
1-Transducer Cable position and unscrew the two parts of the holder
1-SSxxx Transducer
1-Transducer Holder
1-Raptor Interface Cable
1-StringScan II Encoder Body
Place the encoder rings over the inner holder piece Feed the transducer cable through the outer and
inner pieces.

Connect the transducer and feed back into the housing Secure the transducer in the housing with the set
screw insuring the transducer is flush with the
housing front surface.
Screw the housing halves together. Insure the encoder rings are free to rotate.

Place the transducer holder into its ZERO park position Zero park position
Connect the transducer cable to the Raptor T/R port Connect the Raptor interface cable to the
Scanner / Utility port

Connect the scanner interface cable to the Select 5 SCAN on the Raptor and press ENTER
StringScan II encoder body.
Select 5 SCANNER on the Raptor and press ENTER Select SS2 – String Scanner 2 from the list and
press ENTER

Select 1 NEW Cscan and press ENTER Enter the X/Y lengths, index size, scan axis and
test information, highlight ACCEPT and press
ENTER.
Place the transducer holder at the ZERO park ZERO park position
Position and press ENTER

Place the transducer holder on the lower left corner Lower left corner position.
Of the test piece and press ENTER
Select 1 START SCAN and begin scanning test piece.