Nemesis OSCA-O4 User manual

1
PERFORMANCE INSURANCE
PRODUCTION TOOLS •SHOW CONTROL •BACKUP SOLUTIONS
www.nemesis-research.com
OSCA-O4
4-Channel OSC Relay Output
USER GUIDE

2
PERFORMANCE INSURANCE
PRODUCTION TOOLS •SHOW CONTROL •BACKUP SOLUTIONS
www.nemesis-research.com
Overview
The OSCA-O4 is a next generation multiple command destination show control solution
featuring OSC Network input, POE or 5v DC powering and four independent “volt-free dry
closure” relays rated at 0.5 amp 60vdc or 100vac (max)
Front Panel
Rear Panel Connections
Power & Network – OSCA can be powered by POE or 5v DC via the USB C port
4 Display LED’s – LED will come on when relay is closed
GPO Relays – 4 Volt-free dry closure relays rated at 0.5 amp 60vdc or 100vac (max). Connect
your device across a pair marked +/-. Do not exceed the current or voltage of 0.5 amp 60vdc or
100vac per relay otherwise damage will be incurred. Do not connect 240v AC units directly to
the OSCA-O4.

3
PERFORMANCE INSURANCE
PRODUCTION TOOLS •SHOW CONTROL •BACKUP SOLUTIONS
www.nemesis-research.com
Network Settings
Default IP settings
IP Address
192.168.1.253
Subnet Mask
255.255.255.0
Gateway
192.168.1.1
DNS Main
192.168.1.1
DNS Backup
192.168.1.1
Network Device Name
OSCA-O4
OSC Listen Port
53500
In order to change settings navigate to the device's IP address (default: 192.168.1.253) on the
network using a web browser or use its network device (default: OSCA_O4) and navigate to the
“Network page”
In order for changes to take effect press save and then restart (Please note if you have changed
IP address or device name the page may not refresh, and you will need to open a new tab in your
browser with the new user settings).
Relay Settings
You can Manually toggle the 4 relays using the toggle switches on the relays setting page. This
will also update if the relay state is changed via OSC.
To turn relays on and off send the following messages to the device via OSC (make sure the
transmitting device’s send port matches the device's listen port and is sending to the correct IP
address).
Address
Integer Argument
Action
/relay/1
1
Relay 1 On
/relay/2
0
Relay 2 Off
You can also use wildcards to address multiple relays:
Address
Integer Argument
Action
/rela/y[1-3]
1
Relay 1,2,3 On
/relay/[1,4]
0
Relay 1,4 off
You can also pulse a relay for a duration between 100 and 3000ms:
Address
Integer Argument
Action
/relay/[1-3]
500
Relay 1,2,3 On for 500ms
Firmware Update
If connected to the internet you can us ethe Firmware update page to install latest firmware
form the Nemesis server.
Additional Information
Power
OSCA can be powered by POE or 5v DC via the USB C port

4
PERFORMANCE INSURANCE
PRODUCTION TOOLS •SHOW CONTROL •BACKUP SOLUTIONS
www.nemesis-research.com
Factory Reset
Press the reset button at power on to reset the network settings to default. Please then power
cycle the unit for the changes to take effect.
- END OF DOCUMENT -