Nemschoff Palisade 2.0 User manual

Tools Required
Parts Included
Nemscho Palisade 2.0
Privacy Screen Installation Instructions
How to assemble your privacy screen.
Step 
Step 
M-** Multiple and Tandem Seating Unit
1.1 Remove back upholstered panel on 867M-** by removing 2 fasteners,
bottom, back side of unit. Slide panel down and set aside.
2.1 Add 2 top brackets, using hardware kit screws into existing top link
holes.
Utility Knife
Privacy Screen
Top Mounting Bracket Welment Screen Bracket Bottom Screen Bracket
Lower Screen Bracket Screen Connector
(867H Only)
Upper Screen Bracket Washer Machine Screw Flat Head Cap Screw
Power Drive
Washer
Fastener
Machine
Screw
Top Mounting
Bracket
Rear Upholstered Panel
1Nemscho for Palisade 2.0 Assembly Instructions1BMFBF rev A

2Nemscho for Palisade 2.0 Assembly Instructions1BMFBF rev A
Step  Step 
3.1 Slip bottom brackets into rear stretcher. Align bracket hole with hole
used to mount rear panel.
4.1 Slip rear upholstered panel into place. Replace bottom fasteners,
capturing bracket.
Step  Step 
5.1 Slip privacy screen over bottom bracket(s) lip, maintaining vertical
position. Line up holes in privacy screen with top bracket holes.
6.1 Insert flat head cap screw, 2 places, securing screen to top brackets,
2 places.
Lower Screen
Bracket
Privacy Screen
Rear Upholstered Panel
Flat Head
Cap screw

3Nemscho for Palisade 2.0 Assembly Instructions1BMFBF rev A
Step  Step 
D- Daystand
7.1 Attach bracket to daystand top using pan head machine screws
provided.
7.2 Using bracket as a template, drill 3/4” deep pilot hole through
laminate surface into panel.
8.1 Slip privacy screen over bottom bracket lip, maintaining vertical
position. Line up holes in privacy screen with top bracket holes.
Step 
9.1 Insert flat head cap screw, 2 places, securing screen to top brackets,
2 places. 10.1 Feel for hole with nger, then carefully cut with sharp utility knife by
using approximate measurement given below.
10.2 Remove fabric from area around bracket mounting hole location, top
bracket mounting locations. Take care not to extend fabric cuts more than
¼ inch from hole center. Repeat same for other hole mounting locations.
Step 
H-** Booth Seating Unit
Approx.
9-5/8”
up from
bottom
Approx. 12-1/2”
from side
9-5/8”
1/2”
12-1/2”
12-1/2”
22-1/8”
Weldment
Screen
Bracket
Privacy Screen
Flat Head
Cap screw
Utility Knife

4Nemscho for Palisade 2.0 Assembly Instructions1BMFBF rev A
10.1 Install the top brackets. 11.1 Install bottom bracket into slot, bottom rear of booth
unit. Secure with ¼-20 fastener.
Step  Step 
Step  Step 
12.1 Slip privacy screen over bottom bracket lip, maintaining vertical
position. Line up holes in privacy screen with top bracket holes.
13.1 Insert flat head cap screw, 4 places, securing screen to top brackets,
4 places.
Privacy Screen
Upper
Screen
Bracket Lower Screen
Bracket
Washer Washer
Machine Screw
Machine
Screw
Lower Screen
Bracket
Bottom Screen
Bracket
Bottom Screen
Bracket
Flat Head
Cap screw
Slide in screen connector,
half in each screen approx.
4” in from top and bottom edge.