Neptronic IMC10 User manual

Room Control Switch
Specification and Installation Instructions
Specification and Installation Instructions
IMC10-201116 www.neptronic.com Page | 1
Models
IMC10
Features
•Press push button to switch between off, continuous and intermittent
operation modes.
•In intermittent mode, the operation type is alternated based on the time
interval selected by the DIP switches (15, 30, 45 or 60 minutes).
•LED status indications for operation mode and power.
•Three wire connection between switch and CMU.
IMC10
Technical Data
Specification
IMC10
Description
Push button room control switch that can be used with the CMU series compact make-up
air units.
Electrical Connection
3 wires 0.8 mm2[18 AWG] minimum
Power Supply
24Vac
Power Consumption
1VA
Operating and Storage Temperature
0ºC to 50ºC (32ºF to 122ºF)
Relative Humidity
5 to 95 % non condensing
Ingress Protection
IP 30 (EN 60529)
Weight
60 g. [0.13 lb]
Power LED (left)
Turns green if the device is powered on.
Turns OFF if the device is powered off.
Operation Mode LED (right)
Turns green if the device is in continuous operation mode.
Turns white if the device is in intermittent operation mode.
Dimensions
A = 3.00”| 78mm
B = 3.00” | 78mm
C = 1.00” | 24mm
D = 2.36” | 60mm
Wiring
1
2
3
COM
OUTPUT
24V
Connect to
CMU
ON
DS1 Intermittent Operation Mode | DS1
3 4 Result
OFF OFF 15 mins On / 15 mins Off
ON OFF 30 mins On / 30 mins Off
OFF ON 45 mins On / 45 mins Off
ON ON 60 mins On / 60 mins Off
TB1
12 3 4
Not
Used
A
B
C
D

Room Control Switch
Specification and Installation Instructions
IMC10-201116 www.neptronic.com Page | 2
Mounting Instructions
CAUTION: Remove power to avoid a risk of malfunction.
A. Remove the captive screw that’s holding the base and the front cover of the room setpoint sensor enclosure.
B. Lift the front cover of the enclosure to separate it from the base.
C. Pull wire through the hole in the base.
D. Secure the base to the wall using wall anchors and screws (supplied). Make the appropriate connections.
E. Mount the control module on the base and secure using the screw.
Recycling at end of life: please return this product to your Neptronic local distributor for recycling. If you need to find the nearest
Neptronic authorized distributor, please consult www.neptronic.com.
AB
E
D
C