NEUTRIK opticalCON DRAGONFLY User manual

ASSEMBLY INSTRUCTION
®
opticalCON DRAGONFLY | Contact Crimping
R
1 Wire preparation
2 Required Crimp Tools
Page 1BDA 599 V1
3 Crimp Tool Setup
A
5 mm [ ]
0.197"
Strip the isolation to 5 mm for all wires.
Use follwing AWG Sizes:
POWER - AWG 16
SENSE - AWG 24
A
DMC MH860 Crimp Tool
Crimp DIE POS-XP-POWER
POS-XP-SENSE
A
B
C
D
A
B
Use the correct Crimp DIE. Therefore check the
labeling on the DIE.
Set the sel. No as noted on the Crimp DIE.
Insert the DIE.
Rotate 90° to lock the DIE.
A
B
AB
C D

Draft. Nr.: BDA 599 V1 Update: 2020-05-04
I
www.neutrik.com
Neutrik AG LI T: +423 / 237 24 24 F: +423 / 232 53 93
Neutrik USA Inc. USA T: +1 704 / 972 3050 F: +1 704 / 438 9202
( )
Neutrik UK Ltd. UK T: +44 1983 / 811 441 F: +44 1983 / 811 439
Neutrik Vertriebs GmbH DE / NL / AT/DK T: +49 8131 / 280 890 F: +49 8131 / 280 830
Neutrik France FR T: +33 1 / 4131 6750 F: +33 1 / 4131 0511
Neutrik Tokyo Ltd. JP T: +81 3 / 3663 4733 F: +81 3 / 3663 4796
Neutrik Hong Kong Ltd. HK T: +852 / 2687 6055 F: +852 / 2687 6052
Neutrik India Pvt. Ltd. IND T: +91 / 982 05 43 424 F: +91 / 22 26163 540
R
Data subject to change without prior notice. 2020 NEUTRIK . NEUTRIK are registered trademark of NEUTRI AG. ALL RIGHTS RESERVED.
® ®
©
opticalCON DRAGONFLY Assembly Instruction Contact Crimping
I
4 Contact Crimping
C
Attach the contact to the wire.
Insert the contact from the backside into the crimp
tool.
When totally seated, crimp the contact.
Contact is now crimped and can be inserted in the
chassis.
A
B
C
A
B