Before Getting Started
About your wireless scanner
Note:
New batteries should be fully charged before their first use
USB docking station
USB Receiver
USB recharge cable Strap
Wireless Scanner
It is one on one wireless data communication protocol.
The scanner is already paired with the USB receiver. Just
easily plug USB receiver and start the operation. The scanner
on a real time basis, if the scanner is connected, the barcode is
decoded and transmitted to the remote host without any delay.
If the scanner is not connected or out of range, the data is lost
(status: 2 beeps/4 beeps).
Wake up your wireless scanner
Press and release the trigger on your scanner to activate it.
Your scanner is ready to work when orange LED comes on .
Connect USB receiver to a host computer
The device can be quickly recognized by host computer
without any software/driver installation. Within less than
10 seconds the receiver will flash red to inform the Initialization
is completed.
Recharging the battery
The Red LED comes on when the battery level is low, please
recharge the scanner immediately. When the scanner is
charging, the LED is green (solid). A full recharge (from
completely drained battery) takes approximately 4 hours.
When the scanner is fully charged, the green LED will go off.
How to pair (repair) you scanner and
receiver?
Step 1: Plug the USB receiver to the scanner
Step 2: Trigger the button on the scanner.
Step 3: Devices are successful paired with 1 beep from scanner
and 1 blink from the USB receiver.
Scanner LED indicator
USB receiver LED indicator
Status / indicator
Good Scan
Transmission
Trasmission failure
(in memory mode)
failure
Low battery
Recharge
Operation mode
Sleeping
Beeper Blue LED Green LED Red LED Orange LED
1 beep
4 beeps
2 beeps
4 blink
2 blink
None
1 blink
None
On
None
On
None
On
None
Color
Red
Indication
*High
<Buzzer>
Off
Low
<Vibration motor>
Enable
*Disable
<Memory mode>
Enable
*Disable *10min
<Sleep mode>
30min
always on
Default setting of wireless scanner
•Buzzer : High
•Vibrator: Disable
•Memory mode: Disable
•Power saving (sleep mode): 10min
The default values can be modified by scanning the following
options.
Note: Please scan the following barcode directly with your USB
receiver on. No need to scan start and end configuration
barcodes.
HID USB Keyboard Country
Scan the appropriate country code below to program the
keyboard for your country. As a general rule, the following
characters are supported, but need special care for countries
other than the United States: @ | $ # { } [ ] = / ‘ \ < > ~
Note: Please scan the following barcode directly with your USB
receiver on. No need to scan start and end configuration
barcodes.
Terminator selection
USB-COM
* HID-USB
<Dongle interface selection >
Scan the interferface you wish to use and replug the USB
receiver to active the new setting.
US
Italian
Spanish
French Turkey
German
FinnishPortuguese
DutchCzech
NorwegianBelgian
SwissSwedish
Danish
Japanese
