Nexo Up to 3x L20 Rigging System User manual

PAGE 1 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
LNI-3L20
DP6437 –01a - DI
Up to 3x L20 Rigging System
Contents:
X1 Ceiling Plate
X4 L20 Plate
X8 M10x30 (a)
X18 M10x18 (a)
X2 Main Plate
(a): The type of the screws may differ from the representation
Weight: 28 kg / 62 lb

PAGE 2 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Dimensions:
For fixation, you have the choice between M8 and M10
WARNINGS
Ensure that the mounting location and fasteners can support at least 4 times the weight of all the installed cabinets, auxiliary
equipment and cables.
Use only the provided screws (thread lock coated) and accessories.
Implementation of L20
Prepare the Main plates by screwing the M10x30 screws on the holes (see picture below), do not tighten completely and leave at
least 6mm.
Assemble the L20 Plates on each side of L20 using the M10x18 screws.
CARDIO mode
OMNI Mode


 


 


 


 


 

 




 


 

PAGE 3 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
Assembly on the ceiling plate
Place the assembly below the ceiling plate.
Tighten the screws. Secure with the 4 provided M10x30
screws.
LNI-3L20 frame tilt (+/- 1°)
Holes 1
Holes 2
Holes 3
Holes 4
Holes 5
Holes 6
Holes 7
2x L20
11°
8°
4°
1°
-2°
-5°
-9°
3x L20
8°
6°
3°
0°
-1°
-4°
-8°
Note 1 : Holes 1 are those toward F.O.H.
Note 2 : All angles measurements have been done without cables weight.
Note 3 : Angles are in relation to Horizontal position ( 0° )

PAGE 4 OF 4
- Read this document before using.
- Keep this document.
- Observe all warnings and cautions.
•NEXO cannot accept responsibility for accidents caused by any factor other than defects in this product itself.
•Please check the web site nexo-sa.com for the latest update.