NEXTIVITY Cel-Fi QUATRA 4000 User manual

Safety Precautions
• Use Cel-Fi indoors. It should not be used outdoors.
• There are no user serviceable parts inside
Warranty
Nextivity Inc provides a limited warranty for its
products. For details, please refer to http://cel-.
com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users,
be liable under contract, tort, strict liability,
negligence or any other legal or equitable theory
with respect to the Products or any other subject
matter of this Agreement (i) for any lost prots,
cost of procurement of substitute goods or
services, or special, indirect, incidental, punitive, or
consequential damages of any kind whatsoever
or (ii) for any direct damages in excess of (in the
aggregate) the fees actually received by Nextivity
from End User with respect to the Products
actually purchased and paid for.
See cel-.com for list of patents covering this
product.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are trademarks
of Nextivity, Inc.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE
with your wireless provider and have your provider’s
consent. Most wireless providers consent to the
use of signal boosters. Some providers may not
consent to the use of this device on their network.
If you are unsure, contact your provider.
You MUST operate this device with approved
antennas and cables as specied by the manufacturer.
You MUST cease operating this device immediately
if requested by the FCC, Innovation, Science and
Economic Development Canada or a licensed wireless
service provider.
WARNING:E911 location information may not be
provided or may be inaccurate for calls served by
using this device.
FCC Statement (Applicable in the USA only)
When used with any mobile device utilizing the
1710–1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10
meters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC
enforcement action.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protec-
tion against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the instruc-
tions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help
PRODUCT INFORMATION
Cel-Fi™QUATRA 4000
Smart Cellular Coverage
PRODUCT INFORMATION
Cel-Fi™QUATRA 4000
Smart Cellular Coverage
STOP!!! Do not call your service provider
until you have read the Quick Start Guide.
STOP!!! Do not call your service provider
until you have read the Quick Start Guide.
MODEL NUMBERS:
Q44-1234CNU
Q41-5ECU
MODEL NUMBERS:
Q44-1234CNU
Q41-5ECU
Safety Precautions
• Use Cel-Fi indoors. It should not be used outdoors.
• There are no user serviceable parts inside
Warranty
Nextivity Inc provides a limited warranty for its
products. For details, please refer to http://cel-.
com/warranty.
Limitation of Liability
In no event shall Nextivity, nor its directors,
employees, agents, suppliers or End Users,
be liable under contract, tort, strict liability,
negligence or any other legal or equitable theory
with respect to the Products or any other subject
matter of this Agreement (i) for any lost prots,
cost of procurement of substitute goods or
services, or special, indirect, incidental, punitive, or
consequential damages of any kind whatsoever
or (ii) for any direct damages in excess of (in the
aggregate) the fees actually received by Nextivity
from End User with respect to the Products
actually purchased and paid for.
See cel-.com for list of patents covering this
product.
Trademark
Cel-Fi, IntelliBoost, and Nextivity logo are trademarks
of Nextivity, Inc.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE
with your wireless provider and have your provider’s
consent. Most wireless providers consent to the
use of signal boosters. Some providers may not
consent to the use of this device on their network.
If you are unsure, contact your provider.
You MUST operate this device with approved
antennas and cables as specied by the manufacturer.
You MUST cease operating this device immediately
if requested by the FCC, Innovation, Science and
Economic Development Canada or a licensed wireless
service provider.
WARNING:E911 location information may not be
provided or may be inaccurate for calls served by
using this device.
FCC Statement (Applicable in the USA only)
When used with any mobile device utilizing the
1710–1755 MHz band, the FCC limits booster
equipment placement to a maximum of 10
meters above ground level. Installation of this
equipment which does not comply with federal
requirements may subject the owner to FCC
enforcement action.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protec-
tion against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the instruc-
tions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help

WARNING: In order to comply with FCC/ISED
RF Exposure requirements, this device must be
installed to provide at least 20 cm separation from
the human body at all times.
ISED STATEMENT
BEFORE USE, meet all requirements set out in
CPC-2-1-05.
This device may operate in a xed location only, for
in-building use.
In order to comply with FCC/ISED RF Exposure
requirements, this device must be installed to
provide at least 20 cm separation from the human
body at all times.
[FRENCH: Afin de se conformer aux exigences
d’exposition RF FCC / ISED, cet appareil doit
être installé pour fournir au moins 20 cm de
séparation du corps humain en tout temps.]
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For
situations when multiple carrier signals are
present, the rating would have to be reduced by
3.5 dB, especially where the output signal is re-
radiated and can cause interference to adjacent
band users. This power reduction is to be by
means of input power or gain reduction and not by
an attenuator at the output of the device.
[FRENCH: La puissance de sortie nominale
indiquée par le fabricant pour cet appareil concerne
son fonctionnement avec porteuse unique. Pour
des appareils avec porteuses multiples, on doit
réduire la valeur nominale de 3,5 dB, surtout si le
signal de sortie est retransmis et qu’il peut causer
du brouillage aux utilisateurs de bandes adjacentes.
Une telle réduction doit porter sur la puissance
d’entrée ou sur le gain, et ne doit pas se faire au
moyen d’un atténuateur raccordé à la sortie du
dispositif.]
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause
undesired operation of the device.
[FRENCH: L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter toutz brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.]
Gain 100 dB
Bandwidth 75 Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22 dBm // Band 5: 20 dBm
Downlink 16 dBm // Band 5: 13 dBm
Compliance Contact
In the event of regulatory compliance issue, please
contact Nextivity Inc. directly. Contact information
is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
cel-.com for details.
Copyright
Copyright © 2019 by Nextivity, Inc. All rights
reserved. Reproduction or media conversion by
any means is protected by copyright and may only
occur with prior written permission of Nextivity.
Designed by Nextivity in California.
If you need help, visit: www.cel-.com/support.
Bureau in Europe
Unit 6, Basepoint Business Centre
Rivermead Drive, Westlea
Swindon SN5 7EX
U.S. Headquarters: Nextivity Inc.
16550 West Bernardo Drive
Bldg. 5, Suite 550
San Diego, CA 92127, USA
+1 858.485.9442 tel
+1 858.485.9445 fax
www.cel-.com
Nextivity Singapore Pte. Ltd.
2 Changi Business Park Avenue 1
Level 2 – Suite 16,
486015 Singapore
Bureau in Europe
Unit 6, Basepoint Business Centre
Rivermead Drive, Westlea
Swindon SN5 7EX
U.S. Headquarters: Nextivity Inc.
16550 West Bernardo Drive
Bldg. 5, Suite 550
San Diego, CA 92127, USA
+1 858.485.9442 tel
+1 858.485.9445 fax
www.cel-.com
Nextivity Singapore Pte. Ltd.
2 Changi Business Park Avenue 1
Level 2 – Suite 16,
486015 Singapore
legal_quatra4000--eng_19-1119 legal_quatra4000--eng_19-1119
WARNING: In order to comply with FCC/ISED
RF Exposure requirements, this device must be
installed to provide at least 20 cm separation from
the human body at all times.
ISED STATEMENT
BEFORE USE, meet all requirements set out in
CPC-2-1-05.
This device may operate in a xed location only, for
in-building use.
In order to comply with FCC/ISED RF Exposure
requirements, this device must be installed to
provide at least 20 cm separation from the human
body at all times.
[FRENCH: Afin de se conformer aux exigences
d’exposition RF FCC / ISED, cet appareil doit
être installé pour fournir au moins 20 cm de
séparation du corps humain en tout temps.]
The Manufacturer’s rated output power of this
equipment is for single carrier operation. For
situations when multiple carrier signals are
present, the rating would have to be reduced by
3.5 dB, especially where the output signal is re-
radiated and can cause interference to adjacent
band users. This power reduction is to be by
means of input power or gain reduction and not by
an attenuator at the output of the device.
[FRENCH: La puissance de sortie nominale
indiquée par le fabricant pour cet appareil concerne
son fonctionnement avec porteuse unique. Pour
des appareils avec porteuses multiples, on doit
réduire la valeur nominale de 3,5 dB, surtout si le
signal de sortie est retransmis et qu’il peut causer
du brouillage aux utilisateurs de bandes adjacentes.
Une telle réduction doit porter sur la puissance
d’entrée ou sur le gain, et ne doit pas se faire au
moyen d’un atténuateur raccordé à la sortie du
dispositif.]
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause
undesired operation of the device.
[FRENCH: L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter toutz brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.]
Gain 100 dB
Bandwidth 75 Mhz
Input and Output
Impedances
50 ohm
Output
Power
Uplink 22 dBm // Band 5: 20 dBm
Downlink 16 dBm // Band 5: 13 dBm
Compliance Contact
In the event of regulatory compliance issue, please
contact Nextivity Inc. directly. Contact information
is available at www.nextivityinc.com.
Patents
This product is covered by Nextivity, Inc., US
patents and patents pending. Please refer to
cel-.com for details.
Copyright
Copyright © 2019 by Nextivity, Inc. All rights
reserved. Reproduction or media conversion by
any means is protected by copyright and may only
occur with prior written permission of Nextivity.
Designed by Nextivity in California.
If you need help, visit: www.cel-.com/support.