Nexus NX2 User manual

performance by NEXUS NETWORK
Installation Manual English
Installationsanvisning svensk
Installations-Anleitung Deutsch
Manuel d’Installation Français
Log transducer
Loggivare
Log Geber
Capteur Loch

LOG Svenska
10-1

Svenska LOG
10-2
This manual is written for NX2 Log transducer 1.00
Edition: September 2002

LOG Svenska
10-3
Mounting instruction Nexus/Star log/temp transducer
CONTENTS:
1. General
2. Part specification
3. Location of the paddle wheel transducer
4. installing the through-hull fitting
5. Connection to instrument/contacts
6. Calibration
7. Technical data
6. Warranty
1 GENERAL
The log/temp transducer is an impeller transducer installed through the hull and designed to meet
the requirements of owners of sailing crafts and power boats.
2 PART SPECIFICATION
1# Mounting instruction
1# Warranty card
1# Paddlewheel transducer
1# Dummy plug
1# Silicone grease
4# O-ring
1# Through-hull fitting with nut
1# Locking device
5# Extra cable protectors (0,25 mm)
5# Extra cable protectors (0,75 mm)
English

Svenska LOG
10-4
3. CORRECT LOCATION OF PADDLEWHEEL TRANSDUCER
Generally the transducer should be placed as far forward as possible along the waterline length
and close to the centreline.
It is important that the transducer is always in the water, within the whole speed range of
the boat. Please note that the actual waterline length of fast power boats shortens considerably
at high speeds. Therefore the transducer should be placed at 25-35% along the true waterline
from the bow, when at full speed
Example:
English