NI Climbing Frames 128 User manual

128 BBQ Instruction Manual

Parts List
Item
Number
Description
Image
Quantity
1
Small Side
Walls
4
(2 with
notches
cut out
for
support)
2
Horizontal
Pieces
4 (2 x
85cm
long, 1 x
approx.
90cm
long, 1 x
74cm)
3
Supports
4

4
Tall Side
Walls
2
5
Top
Horizontal
1
6
Back Wall
1

7
Chimney
1
8
Chimney
Cap
1
9
Chimney
Cover
1

10
Side Walls
for
Worktop
Supports
2 (these
may
come in
two parts
and need
cemented
together)

Assembly Instructions
All components needed during the assembly are numbered with reference to the parts list, please
refer back to the parts list to ensure you are assembling the correct components for each step.
NOTE: Ensure you have solid ground to install your BBQ on before you start assembly.
Step 1:
•The first step is to mark out where your BBQ will be placed, there needs to be 640mm
between the side walls. Take two of the small side walls (without notches) and the two tall
walls for the worktop supports, add a layer of cement to the bottom of all walls to secure
them to the ground and place them where you have marked out, ensuring the walls are
plumb and level. Ensure the notches cut out of the tall walls are at the front and are facing
in.

Step 2:
•Secure the longer horizontal piece to the two small side walls using cement. Ensure the
horizontal part is level and centred so that there is equal overhang at the front and back and
at the two sides.

Step 3:
•Secure the other two small side walls (the ones with the notches cut out) to the horizontal
piece using a layer of cement. Ensure these two walls are directly above the bottom two
small side walls and that they are plumb and level.

Step 4:
•Secure the three supports into the notches cut out of the side walls using a layer of cement,
ensure the supports are level with the top of the side walls.

Step 5:
•Secure the 74cm horizontal to the top of the two small walls using a layer of cement. Make
sure the horizontal is centred and level.

Step 6:
•Secure the other two horizontals to the top of the small walls and to the taller walls. These
horizontal should be up tight to the horizontal assembled in the previous step. Secure using
cement.

Step 7:
•Secure the two tall side walls using a layer of cement. Ensure the walls are lined up directly
above the small side walls and that they are plumb and level. Make sure the orientation of
them is correct and the notches are in the correct position for the support to fit into and for
the back wall to fit into.

Step 8:
•Secure the back wall to the two side walls by fitting it into the notches cut out of the two
side walls and securing using cement. Make sure the back wall is flush with the back of the
two side walls and that the top of the back wall is flush with the top of the side walls.

Step 9:
•Secure the final support by fitting it into the notches and securing using cement. Ensure the
top of the support is level with the top of the side walls.

Step 10:
•Secure the top horizontal piece using a layer of cement, ensure it is level and centred and
that the wider part is at the front.

Step 11:
•Secure the chimney using a layer of cement and make sure that the back of the chimney is
flush with the back of the horizontal piece.

Step 12:
•Place the cap and the cover on the chimney and leave to fully dry before using the BBQ.