Nilfisk-Advance Advolution 2710 User manual

Advolution 2710 Rider Burnisher How To
Prepare for use
1
Before burnishing: Pre-
sweep or scrub floor area
to prevent scratching.
2
Onboard charger:
Disconnect battery
Store cord inside
machine frame.
3
Shelf charger:
disconnect then
connect machine to
batteries.
4
Lift and lock deck to
inspect burnishing pad
for wear.
5
Turn pad retainer
counter clockwise to
remove the pad.
6
Install new pad and
center on outside
diameter. Tighten pad
retainer clockwise.
7
Verify dust collection
bag is installed.
8
Store additional dust
collection bags here.
9
Adjust steering wheel –
tilt to comfort.
10
Adjust seat if needed.
11
Turn on machine. Verify
battery power.
12
Use motion control
pedal for forward and
reverse. Transport
machine to work area.

Advolution 2710 Rider Burnisher How To
Helpful Tips – Display Buttons
1
Press green button:
lowers burnishing head
and activates
burnishing motor.
2
Horn button
3
Hour meter & Error
Display.
Advolution 2710 Rider Burnisher How To
Adjusting Burnishing Pressure
1
Turn key switch OFF
2
Hold burnishing button
and turn on key.
3
Select 1,2 or 3 then
turn OFF key to set
burnishing pressure
option.
Advolution 2710 Rider Burnisher How To
Efficient Burnishing
1
Have an organized
route for the area to be
cleaned.
2
Drive machine at a
consistent speed. Have
a consistent overlap.
3
DO NOT STOP –
stopping while pad is
running will leave
circles on the floor.

Advolution 2710 Rider Burnisher How To
Store the Machine
1
Transport machine to
storage and charging
station.
2
Inspect burnishing pad.
3
Open seat
compartment, connect
the charger and wipe
down the exterior of the
machine.
Advolution 2710 Rider Burnisher How To
Daily & Occasional Maintenance
1
Charge batteries daily.
2
Check/Clean/Replace
Burnishing Pad.
3
Check/Clean/Replace
Dust Collection Bag.
4
Check Battery water
level(s).
Check/Replace Pad
Shroud Skirt.
5
Check steering chain
tension, lubricate
steering wheel shaft
universal joint
6
Check carbon brush
wear on pad, wheel
drive and actuator
motors.
* Should be performed
by an Authorized
Service Center
Monthly Maintenance
Yearly Maintenance
Weekly Maintenance