Nilfisk-Advance SC1500 56104002 Operating instructions

3. C heck the vacuum hose is
connected to the squeegee
2. F ill-in the tank with clean water.
Check if the Ecoflex bottle is well
installed (only for machine with
1. Check the battery charge gauge 4. Check the brush is clean 5. Install the brush on the deck
(and if necessary re-charge).
Ecoflex)
16. Remove and clean the debris tray 17. Wash the recovery tank with clean 18. Remove debris from the brushes
water
19. Take the squeegee off and check
the blades’ wear status
13. P ress the forward pedal, select the
direction and start operating the
machine
11. Select double pressure if needed 12. Select silent mode if needed 14. Open the crew cap and empty the
recovery tank with the squeezable
hose
15. If necessary, empty the solution
tank through the solution valve and
clean the filter net
6. Check if the solution filter is clean 7. Stand on the machine and turn on 8. Press the One-Touch button
the key (squeegee lowers automati-
9. Adjust to the desired water flow 10. A djust to the desired chemical
concentration
cally)
20. Clean the machine using a damp
cloth and park it with the recovery
OPERATING GUIDELINES
SC1500
tank open
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
ATTENTION! Do not use the machine before you have read and understood the User Manual

TROUBLESHOOTING
SC1500
ATTENTION! Do not use the machine before you have read and understood the User Manual
The machine
doesn’t work
as it should?
1 Check if the power cable is
correctly connected
The suction
doesn’t work
as it should?
1 Check the vacuum hose is
connected to the squeegee
The machine
doesn’t clean
as it should?
1 Check to have solution into the
tank
The brush
don’t work as they
should?
1 Check if the brush is correctly
installed and not worn out
2 Check the battery charge gauge
(and if necessary re-charge)
2 Open the recovery tank and
check if the gasket and
vacuum grid are cleaned
2 Check if you have the right water
setting
2 Check the brush is cleaned
3 Check if squeegee blades
are damaged or dirty
3 Check if there are external materials
avoiding brush rotating
4 Close the recovery tank
properly and/or verify the
gasket wear
3 Check if the filter is cleaned
5 Check to have suction
button activated