Nilfisk-Advance Warrior 34RST Administrator Guide

Warrior/34RST with EcoFlex How To
Prepare for use
1
This is how the
machine should look
when you enter the
room.
2
Unplug battery charger.
Wrap cord accordingly.
3
Inspect recovery tank
then lower the lid.
4
Fill solution tank with
water (do not exceed
130°F). Add appropriate
cleaning chemical.
5
Do not mix detergent in
the tank for EcoFlex
models.
6
Inspect squeegee
blade, install squeegee
on machine and attach
recovery hose to the
squeegee inlet.
7
Inspect brush or pad.
8
Install brush or pad-
holder under the deck.
9
Install brush for
Cylindrical models
10
Turn on machine. Verify
there is enough battery
life to complete job.
11
Use paddle to move
forward or reverse.
Adjust speed of
machine as needed.
12
Turn on scrub switch,
lower squeegee lever
and begin scrubbing.

Warrior/34RST How To
Store the Machine
1
Empty recovery tank
and solution tank.
Empty water in suitable
drain or bucket.
2
Wash recovery tank
and vacuum grid inlet
filter with clean water.
3
Remove vacuum motor
inlet screen. Do not
allow water to enter the
Vacuum motor inlet
screen while cleaning.
4
Inspect hoses; replace
if kinked or damaged.
5
Remove, rinse and
inspect squeegee.
Replace if needed.
6
Remove, clean and
inspect brush or pad.
Rinse with warm water.
Hang to dry. Replace if
needed.
7
Lift recovery tank lid.
8
Charge batteries.
9
Wipe down exterior of
the machine.

Warrior/34RST How To
Daily Maintenance
1
Charge Batteries
2
Check and clean
recovery and solution
tank and hoses.
3
Clean recovery tank
switches and vacuum
inlet screen.
4
Check, clean and rotate
the brushes/pads.
5
Clean and check the
squeegee.
6
Clean Hopper on
Cylindrical models.
Weekly Maintenance
1
Inspect scrub housing
skirts (34 RST models)
2
Inspect and clean
solution filter.
3
Check each battery cell
water level (does not
apply to gel batteries)
4
Clean solution
manifolds on Cylindrical
models.
5
Disconnect and remove
cartridge, turn machine
ON. Press and hold the
solution switch for 2
seconds.
6
Monthly: Apply light oil
to lubricate machine
(see manual for details)
Yearly:
Check carbon brushes
Occasional
Maintenance