Nixzen NX-N-USP201V User manual

Single Channel Video Surge Protector
User Manual
The video surge protector meets the provisions of national standard IEC61643-
21:2000,protecting the equipment from damage due to monitor system signals induced
overvoltage, operating overvoltage and electrostatic discharge .It features multilevel protection、
large flow capacity、low voltage limited、quickly response and low insertion loss.
Features
2
1
Please check the following accessories before installation, if you find out the item miss,
please contact your local dealer
Single Channel video surge protector 1PCS
User Manual 1PCS
Installation steps
1) Check if the grounding resistance meets the specification before connect the device to
system.
2) Connect the protector to the remote device and make sure it’s connected reliably.
3) Connect the device ground wire to protection groud strap keeping in the shortest
possible distance. ground wire should be as shortest as possible.
Installation steps
Panel diagram
Note:
1) Make sure the connection of the plug IN, plug Out, output device and protected device
assembly following the instruction. Otherwise it will cause the damage to the protected
device.
2) If the loss increase is caused by the function of the plug, please replace it.
3) Any dismantle of the component by the user is not allowed. Inappropriate dismantle will
Application
Single Channel Video Surge Protector
CCTV camera
Monitor
Grounding
Coaxial
Grounding
Surge Protector
Output
Grounding
Input
Grounding
Multi-Level protection;
Large flow capacity;
Low voltage limited;
Quickly response;
Low Insertion loss;
V2.1
Surge Protector

Specifications
4
3
If product specifications change ,no notice.
Troubleshooting
1 Protector does not need repairmen, if damaged by high -pressure, lighting, please
change the protector.
2 Use the three table“Ω×10” range measuring protection input and output wire. The
value should be 4.7Ω；If the circuit is opening, it means the protector is out of function,
please replace by another protector.
3
400kΩ。If measured resistance is not match with it,
)
)
) Use the three table“Ω×1M” range measuring wire line resistance to mine. The value
should be about please replace
by another protector.
Item
Specification
Video
Rated working voltage
5V
Max continuous operating voltage
6V
Nominal discharge current （8/20µs）
5KA
Max discharge current （8/20µs）
10KA
Impact limit voltage （10/700/µs）
<20V
Insulation resistance
≥0.4MΩ
Insertion loss
≤0.5dB
VSWR
≤1.2
Bandwidth
0.3-10M
Response time
≤1ns
Environment
Working Temperature
0℃~55℃
Storage Temperature
-40℃~80℃
Humidity
0~95%
Physical
Properties
N.W.
68g
Size
65mm×25mm×25mm（With Port Lenght）
Material
Aluminum
Stability
MTBF
>30000h
Single Channel Video Surge Protector
Single Channel Video Surge Protector