Nokta RS PinPointer User manual

QUICK GUIDE
www.noktadetectors.com

NOKTA DETECTORS
INTRODUCTION
WARNINGS and REMINDERS
Thank you for choosng and purchasng our Nokta RS Pnponter.
Nokta RS Pnponter s a hand-held metal detector desgned to pnpont targets
detected by conventonal metal detectors.
Do not expose the devce to very hot (for example, nsde a hot car) or cold condtons
for extended perods of tme.
RS Pnponter s not a dggng tool. Do not use t for dggng or extractng stones or
metals.
Only the end of the probe s waterproof. Do not mmerse the control box n water; do
not expose the devce to extreme humd condtons.
Do not use the devce to locate power lnes. Usng the devce near power lnes may
cause harm to the devce.
Always keep the devce o when not n use. Ths wll help ncrease battery lfe and
devce performance.
Sudden changes n ambent temperature can drastcally aect the performance of
the devce. Therefore, t s recommended not to use the devce mmedately after sudden
temperature changes but to wat for approxmately 10 mnutes.
Audo alert consumes less battery power than vbraton alert. Usng the audo alert
when possble wll extend battery lfe.
For Consumers within the European Union: Do not dispose of this equipment in general
household waste. The crossed wheeled bin symbol on this equipment indicates this unit should
not be disposed of in general household waste, but recycled in compliance with local
government regulations and environmental requirements.
FCC STATEMENT: This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Audio / Vibration / OBattery Cover Light Sensor 360° Detection
Waterproof Pinpointing Tip
LED Flashlight

Low Battery Life Alert: When the battery s low, the devce wll sound 3 beeps at start
up and wll contnue workng untl the battery des.
NOKTA DETECTORS
OPERATING INSTRUCTIONS
Battery: To open the battery compartment, place your thumb on the recess, press
down and slde forward. Insert the suppled 9V battery payng attenton to the plus (+)
and mnus (-) poles. If the battery s nserted n the wrong drecton, the battery cover wll
not close.
LED Flashlight: LED ashlght wll lght up automatcally n the dark. Except n very
brght envronments, you can also actvate the LED ashlght by coverng the lght
sensor on the devce wth your fnger.
Turning O the Device: To turn the devce o, press and hold the push button for a
few seconds. The devce wll produce 6 short beeps and turn o. Always keep the devce
o when not n use.
Belt Clip Case: When you are not usng the RS Pnponter, you can put t n ts case and
attach t to your belt or wastband so that you can carry t around securely.
Turning On the Device: Before turnng on the devce, hold the devce away from
metallc objects ncludng your watch and jewelry.
To turn on the devce, press and release the push button
once. The LED wll blnk once, a long beep wll be heard and
the devce wll start n the audo mode. To use the devce n the
vbraton mode, press and release the button agan.
Audio or Vibration Alert: To swtch between the modes,
press and release the push button once. When the devce
detects metal, t wll produce an audo or vbraton alert accordng to your mode
selecton. The rate of the pulsng audo or vbratons wll ncrease as the devce gets
closer to the metallc object and t wll decrease as the devce s moved away.
360° Detection: RS Pnponter's detecton
area s from the end of the probe to the
begnnng of the hand-held part and t oers
360° detecton. Ths allows you to easly locate
metals n a hole. It also enables you to quckly
scan a larger area by holdng the RS
Pnponter on ts sde, at aganst any surface
and fnd your target.
Adjusting Sensitivity: The devce has 4 levels of senstvty. When you frst turn on the
devce, t wll start at level 3. When you want to change the senstvty, double clck the
button. The devce wll vbrate and beep at the same tme. The number of beeps heard
ndcate the senstvty level. One beep meanng level 1, two beeps meanng level 2 and so
on. At level 4, f you double clck the button agan, t wll go back to level 1. When you turn
o and on the devce agan, t wll start at the last adjusted senstvty level.