Nora Lighting NX-813-LED User manual

CONTENTS:
- LED Edge-Lit EXIT Sign - Canopy - Hardware Bag
6505 Gayhart St., Commerce, CA 90040
www.NoraLighting.com
Page 1 of 2
Installation Instructions ***URGENT: READ PRIOR TO ATTEMPTING INSTALLATION***
EXIT LIGHTING - RECESSED ADJUSTABLE LED EDGE-LIT EXIT SIGNS
ALWAYS TURN OFF MAIN POWER BEFORE INSTALLATION
Item# Description Rating
NX-813-LED Recessed Adjustable LED Edge-Lit Exit Sign, AC Only 120V/277V
NX-814-LED Recessed Adjustable LED Edge-Lit Exit Sign, 2-Circuit 120V/277V
INSTALLATION SHOULD BE CARRIED
OUT BY YOUR LOCAL ELECTRICIAN.
Electrical Instructions (Save these instructions for future use):
1. Make sure power is off.
2. Fix checron(s) as required to EXIT panel and remove the template from the panel. (Note: When chevron(s) are being taped on
the EXIT panel, you cannot use it again on you remove it. Please be careful before removing chevron).
3.
Use “holding wire/hook” to help support weight of exit sign while wiring the unit.
4. Remove junction box screws and cover plate.
5. Feed AC supply leads through rubber “O” ring on junction box. Make the proper supply lead connections. If using 120VAC,
connect the black and white leads to the building utility. If using 277VAC, connect the orange and white leads to the building
utility. Cap off unused wires. In all cases, use standard wire nuts in connection to leads. (See Wiring Diagram)
6. Place all wires carefully inside junction box and replace junction box plate and screws.
7. Snap EXIT sign into spring bracket inside housing.
8. Mount cover plate and adjust EXIT sign to desired angle from 0º to 90º.
Caution:
• Allelectricalconnectionsmustbeinaccordancewithlocalcodes,ordinances,andtheNationalElectricCode.Ifyouareunfamiliarwith
these methods of installing electrical wiring, refer to the services of a qualified licensed electrician.
• Beforestartingtheinstallation,disconnectthepowerbyturningoffthecircuitbreakerorbyremovingtheappropriatefuseatthefuxebox.
Turning the power off using the light switch is not sufficient to prevent electrical shock.
• Donotuseoutdoor(s).
• Donotmountneargasorelectricheaters.
• Equipmentshouldbemountedinalocationandataheightwhereitwillnotreadilybesubjecttotamperingbyunauthorizedpersonnel.
• Theuseofaccessoryequipmentthatisnotrecommendedbythemanufacturermaycauseanunsafecondition.
• Donotusethisequipmentforotherthanintendeduse.
• Allservicingshouldbeperformedbyqualifiedpersonnelonly.

6505 Gayhart St., Commerce, CA 90040
www.NoraLighting.com
Page 2 of 2
Installation Instructions ***URGENT: READ PRIOR TO ATTEMPTING INSTALLATION***
EXIT LIGHTING - RECESSED ADJUSTABLE LED EDGE-LIT EXIT SIGNS
ALWAYS TURN OFF MAIN POWER BEFORE INSTALLATION
Item# Description Rating
NX-813-LED Recessed Adjustable LED Edge-Lit Exit Sign, AC Only 120V/277V
NX-814-LED Recessed Adjustable LED Edge-Lit Exit Sign, 2-Circuit 120V/277V
Installation Instructions:
1. Reference page 1 for electrical instructions. Install Edge-Lit assembly to recessed kit by spring bracket. (See Fig. 1)
2. Then install trim plate to recessed kit. (See Fig. 2)
3.
Rotate the panel 90º for wall mounting. (See Fig. 3)
INSTALLATION SHOULD BE CARRIED
OUT BY YOUR LOCAL ELECTRICIAN.