Napoli Garden
Weight 270 kg
Non-combustible oor in front of replace
(in NORWAY) 410 mm
Attention! The area in front of the replace must
be of a non-combustible material. Follow the local
rules and requirements.
WARNING!
For your own safety, do not leave the product
unattended whilst there are still ames/hot ember.
Safety distances
Make sure to follow the local rules and regulations
regarding outdoor replaces.
For your own safety, fully comply with the assembly
instructions. All safety distances are minimum distances.
Installation of the insert must comply with the current rules
and regulations of the country where the product is installed.
Nordpeis AS is not responsible for wrongly assembled
products.
Subject to errors and changes.
For the latest updated version go to www.nordpeis.com.
Foundation
Make sure the bottom element is level and placed on a
solid surface able to withstand the weight of the product.
Acrylic glue
The replace is to be assembled using acrylic glue.
Make sure all dust is removed and that the surfaces are
clean. When the replace is assembled, use the same
acylic glue for lling joints (FIG Z)
Minor damage
The replace can sustain minor damage during
transport and handling.
This can be repaired with acrylic/light ller. For perfect
results, you can ll and sand with a suitable ller. Minor
damage and uneven surfaces can be lled. If the
damage is deep or in the event of signicant damage,
you are recommended to ll repeatedly with tile
adhesive or cement putty to avoid sinking. Smooth off
with e.g. a damp sponge or a oat.
Surface treatment
The product is delievered unpainted.
Note that the product should be stored/assembled in dry
conditions.Without any surface treatment, the concrete
will be vaunerable to water and damage.
When the replace has been lled/sanded and the
glued joints are dry, the replace is ready to be painted.
Use only breathable paint (acrylic) intended for
masonry.
