Nordson 1028327 User manual
Instruction Sheet P/N 1029723B
ProBlueP10/15/30 and P50 Operator’s Panel Service Kit - P/N 1028327 Issued 02/05
This instruction sheet describes the procedure for replacing the operator’s
panel on a ProBlue model P10/15/30 or P50 adhesive melter.
WARNING: Risk of personal injury or equipment damage! Refer to
the safety information provided in the melter manual before servicing
the melter. Failure to comply with the safety information provided
can result in personal injury, including death.
Required Tools:
6-mm open-end wrench
Phillips-head screwdriver
4-mm hex wrench
Operator’s Panel
WARNING: Risk of electrocution! The control switch does not remove
high-voltage power from the melter. Before opening the electrical
compartment door, ensure that the local power disconnect switch is in
the off position and that it is locked. Failure to properly disconnect power
from the melter can result in personal injury, including death.
1. Switch the melter off.
2. Disconnect electrical power to the melter at the
local power disconnect switch.
3. Open the electrical compartment door.
4. Disconnect the main board and serial port
ribbon cables from the CPU board.
5. Detach the CPU board by removing
the six threaded spacers and lock washers.
6. Disconnect the two ribbon cables that join the CPU
board and the control panel.
CAUTION: Before handling electrical components, ground
yourself by touching any bare-metal part of the chassis or
another grounded structure. Failure to properly ground yourself
can cause electrostatic discharge resulting in damage to the
CPU board.
J1
CPU Board
7. Detach the electrical enclosure door by removing
the four M5 screws and matching washers.
9. Assemble the new operator’s panel to the
hinges, and then re-attach the electrical enclosure
door.
10. Reinstall the CPU board by reversing steps 3 through 6.
11. Restore electrical power to the melter, and then
switch the melter on. Verify that the melter starts normally.
8. Detach the operator’s panel from both
hinges by removing the four locknuts.
Table of contents
Other Nordson Service Equipment manuals
