FLO-DYNAMICS BrakeMate Jr Programming manual

Flo-Dynamics, Inc. • 2600 Jeanwood Drive • Elkhart, IN 46514 • 800-303-5874 • www.odynamics.com 945013
QUICK START
INSTRUCTIONS
R
BRAKE FLUSH MACHINE
OPERATION
DISCONNECTION
CONNECTION
Remove master cylinder cap. Find correct master cylinder adapter
from adapter kit and attach to master cylinder reservoir. Connect
yellow pressure hose to master cylinder adapter.
Turn the machine on and use the pressure regulator to
increase the pressure to the desired amount. A typical brake
service should not require more than 12psi (see manufacturer’s
recommendation).
After brake ush is complete, turn the machine o and disconnect
the battery cables.
Close ball valve on yellow pressure hose, press and hold Pressure
Release Button to relieve pressure, and then disconnect hose from
master cylinder adapter. Remove the adapter and replace the
master cylinder cap.
Slowly open the ball valve on the yellow pressure hose while
checking for leaks around the master cylinder adapter.
Open the bleeder screw about 1/4 turn until uid begins to ow
into the bottle.
If the new uid tank level becomes too low, the light on front
of machine will illuminate and the machine will beep. To restart
the machine, simply add more uid to the new uid tank.
When nished, close the bleeder screw and remove tube from
tting. Repeat process on the remaining three wheels.
Attach the tube from the used uid bottle to one of the vehicle’s
bleeder screws. You may need to verify that the bleeder screw can
be opened before attaching the tube. The bottle may be mounted
to the caliper using the attached magnet.
Connect the battery cables.

Flo-Dynamics, Inc. • 2600 Jeanwood Drive • Elkhart, IN 46514 • 800-303-5874 • www.odynamics.com 945013
QUICK START
INSTRUCTIONS
R
BRAKE FLUSH MACHINE
DRAIN THE NEW FLUID TANK
Before draining, bypass the uid level sensor located in the new
uid tank by pulling up with a wire loop.
Connect the wand adapter to the yellow hose. Place in an appro-
priate uid container and open the ball valve. Turn the machine on
and turn the pressure knob until uid begins to drain.