
3
Assembly Instructions Porta Table Lamp
General instructions
Please note the information contained in these instructions and save this manual.
Safety precautions:
• The manufacturers do not accept responsibility for injuries or defects caused by improper use
of this lamp.
• This lamp is for indoors use only. It can be taken outdoors but must be kept and stored indoors.
• This lamp should only be charged indoors.
• This lamp should only be used in environments with temperatures from 0~45 C°.
• The charging time from 0-100% is 11 hours. Please only use a 5.0V USB power supply or a low
voltage drive.
• This lamp has 3 light intensity levels: 100%, 70% and 40%.
• The battery life for this lamp is 8 hours at 100% light intensity, 24 hours at 70% light intensity and 90
hours at 40% light intensity.
• The battery used for this lamp is a 3.7V 6000mAh battery.
• The light source of this luminaire is not replaceable; when the light source reaches its end of life the
whole luminaire shall be replaced.
• Please dispose of plastic bag from packaging and do not allow children to play with it.
• Keep product well out of children’s reach.
• Don’t switch the lamp on when it’s in the packaging.
• If the external exible cable or cord is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualied person in order to avoid a hazard.
Maintenance instructions:
• Before cleaning, disconnect the power and allow the lamp to cool down for 10 minutes.
• Mind to clean the surfaces of the lamp only.
• Clean the lamp with a soft dry, cloth only.
• If necessary, wipe the surface of the lamp with a soft, damp sponge or cloth, and wipe
immediately with a dry cloth.
• Do not use alcohol or other solvents to clean the product and avoid using abrasive or
rough sponges.
Advice for environmental care:
Please don’t dispose of this article in normal domestic waste after the end of its lifecycle.
Instead, we advise that you dispose of it according to local environmental laws for waste disposal.
The materials are recyclable according to their specications. With the correct recycling of these materials,
you can make a signicant contribution to environmental protection.
The battery must be removed from the lamp and disposed of according to local environmental laws before
disposing of the lamp.
CE marking:
By axing the CE marking to a product, a manufacturer declares that the product meets all the legal
requirements for CE marking and can be sold throughout the European Economic Area (EEA).