Nortel Meridian M3902 User manual

Analog Terminal Adapter Installation and Reference Guide
N0023538 1 of 3 Standard 2.00
This installation and reference card describes how to install and use the Analog Terminal Adapter (ATA) (NTMN68xx)
with your M3900 Series Digital Telephone.
The ATA allows an off-the-shelf analog device (FAX, modem, or analog [500/2500-type] telephone) to work
simultaneously with your M3902, M3903, M3904, or M3905 Series Digital Telephone.
Note: The ATA is not supported on the M3901 telephone.
Connecting the
analog device
Install the Accessory Connection Module (ACM) (NTMN71AA) into your M3900 Series
Digital Telephone before you install your ATA. The ACM provides connection capabilities
between the M3902, M3903, M3904, and M3905 telephones and the ATA.
A wall transformer is required to connect the ATA to the electrical outlet. Contact your
Nortel distributor for the recommended wall transformer.
To install the ATA:
1. Insert the ATA accessory cartridge into the ACM. The latch must be at the top.
2. Connect the commercial device you have selected to use—either your FAX machine,
modem, or analog (500/2500-type) telephone—to the connection on your ATA
cartridge interface.
3. Plug the wall transformer into an electrical outlet. Use only the transformer designed for
the ATA.
4. Connect the adapter plug, attached to your transformer, into the wall jack.
5. Connect the six-conductor line cord from the telephone to the adapter jack attached to
the wall transformer. Refer to the Accessory Connection Module Installation Guide for
further information.
6. Refer to the manufacturer’s documentation for complete installation and configuration
instructions for your external analog device (FAX, modem, or analog [500/2500-type]
telephone).
Note: The ATA supports connections to Plain Old Telephone Service (POTS) services only.
Features such as Message Waiting, Switchhook Flash/Link, Transfer, Conference,
and CLASS type services are not supported on the attached device.

Analog Terminal Adapter Installation and Reference Guide
Standard 2.00 2 of 3 N0023538
Table 1:
ATA compatibility
Meridian External
Alerter Recording
Interface (MEARI)
Computer
Telephony
Integration
Adapter (CTIA)
Full Duplex
Handsfree (FDHF)
Personal Directory
PC Utility
Analog Terminal
Adapter (ATA)
Yes Yes No Yes
Note: Full Duplex Handsfree (FDHF) cartridge and ATA can be interchanged but cannot be used simultaneously.
Status
light indicator
A red LED status light located on the ATA indicates the status of the ATA.
•Flashing red indicates that the ATA is operating normally. For more troubleshooting
guidelines, refer to the user documentation that came with your analog device.
•Solid red indicates that the ATA is not operating normally. Contact your system
administrator.
•Red light off indicates that there is no power going to the ATA or the unit is not
operating correctly. Check the power connections to the ATA. If problems continue,
contact your system administrator.
System
administration
Flexible voice and data capabilities allow you to have continuous use of both the
M3900 Series Digital Telephone and the attached analog device. Your system administrator
configures the flexible voice and data capabilities for your telephone on the system
equipment. Contact your system administrator for more information about flexible voice and
data capability.
Power
failure
When there is a power failure to the ATA, the analog device does not store or keep
information (for example, outgoing FAX from your FAX machine). You must send the
information again when power returns.
Configuring the
Meridian 1 for use
with an ATA in LD 11
Prompt Response Description
REQ NEW
CHG
Input new data.
Change current data.
CLS aaaa Class of Service options where: aaaa,
= (FLXD) FLXA, required if ATA equipped.
= (VCE), DTA - voice, data terminal, required if
ATA equipped.

Analog Terminal Adapter Installation and Reference Guide
N0023538 3 of 3 Standard 2.00
Configuring the
Meridian SL –100 for
use with the ATA in
Servord
Prompt Response Description
SO NEW
LCC_ACC ATA
LEN_OR_LTID IPEO 00 0 01 1 Enter the odd LEN which is immediately after the
even LEN for the M3900 Series Digital Telephone
to which the ATA is attached.