Norwood sprogs User manual

Activity Table
Standard and Preschool Height

Attach Legs to Table Top
1. Place Table Top (A) face down, on a carpet or protected surface to prevent scratches.
2. Slide Receiver Plate of Top Leg (B) under the edge of one of the corner brackets.
3. Tap the Top Leg (B) into place with a rubber mallet until the pilot hole is visible through the
center hole in the leg plate. If needed, loosen the screws to allow more clearance.
4. Using the Phillips Head Screws (D) (3 per Leg), attach the leg using a Phillips Screwdriver. Do
not use power tools as the screw holes can be stripped from over tightening.
5. Repeat steps 2 through 4 for the other 3 legs. Make sure all screws are fully tightened.

Sprogs Size Leg Norwood Size Leg
Table Leg Height Adjustment
Insert Lower Leg (C) into Upper Leg (B) and line up holes at desired height as shown below.
Fasten each leg with 2 Hex Head Screws (E) using Allen Wrench (F).
Care and Cleaning
Clean table with a damp cloth or sponge using warm water and mild soap. Wipe dry.
Do not place near heat, moisture or vaporizer which may cause table to warp and peel.
Check for loose or worn parts periodically and tighten or replace as necessary.