Novus AH-1J SeaCobra User manual

QUICK START CHECKLIST
WARNING!! The instruction manual must be read completely before
operating the Novus AH-1J SeaCobra. It contains specific warnings about
safety and use of the LiPo flight battery supplied with the Novus AH-1J SeaCobra. All
of these warnings and safety steps must be read and understood before proceeding to
the next step.
❑1. Plug the wall transformer into an AC
outlet. The power indicator light on the wall
transformer will be green and the charge
indicator light will be solid red.
❑2. Plug the battery into the charger. When
the battery is completely charged, the charge
indicator light will turn green (solid or flashing).
Disconnect the battery from the charger.
❑3. Install (8) AA Alkaline batteries into
the transmitter.
❑4. Install the Flight Battery.
™
QUICK START CHECKLIST
WARNING!! The instruction manual must be read completely before
operating the Novus AH-1J SeaCobra. It contains specific warnings about
safety and use of the LiPo flight battery supplied with the Novus AH-1J SeaCobra. All
of these warnings and safety steps must be read and understood before proceeding to
the next step.
❑1. Plug the wall transformer into an AC
outlet. The power indicator light on the wall
transformer will be green and the charge
indicator light will be solid red.
❑2. Plug the battery into the charger. When
the battery is completely charged, the charge
indicator light will turn green (solid or flashing).
Disconnect the battery from the charger.
❑3. Install (8) AA Alkaline batteries into
the transmitter.
❑4. Install the Flight Battery.
™

❑5. Connect the flight battery to the ESC. ❑6. Position throttle stick in lowest position.
❑7.Turn the transmitter on.
❑8. Wait while the transmitter binds to the receiver (the logo on the
transmitter will quit flashing).
❑9. Leave the helicopter still for 5 seconds so the gyro can perform
the initialization process.
A safe start is built into the Novus Helicopter that prevents the motor from activating
unless the collective stick has been lowered to the lowest position. If the motor won’t
run and turn the main blades, please make sure the collective stick is all the way down
and leave it there for a couple of seconds. Then try moving the stick up slowly.
❑
10. Transmitter Controls:
Your Novus AH-1J SeaCobra is now ready to fly. Please refer to the flying instructions on
page 15 in the manual before operating the model.
❑5. Connect the flight battery to the ESC. ❑6. Position throttle stick in lowest position.
❑7.Turn the transmitter on.
❑8. Wait while the transmitter binds to the receiver (the logo on the
transmitter will quit flashing).
❑9. Leave the helicopter still for 5 seconds so the gyro can perform
the initialization process.
A safe start is built into the Novus Helicopter that prevents the motor from activating
unless the collective stick has been lowered to the lowest position. If the motor won’t
run and turn the main blades, please make sure the collective stick is all the way down
and leave it there for a couple of seconds. Then try moving the stick up slowly.
❑
10. Transmitter Controls:
Your Novus AH-1J SeaCobra is now ready to fly. Please refer to the flying instructions on
page 15 in the manual before operating the model.
Copyright © 2009 HMXE0805 Quick Start Copyright © 2009 HMXE0805 Quick Start