NSL PG 40W-aaK Series User manual

PG-XXX-40W-aaK
FIXTURE INSTALLATION
Important: Read all instructions in order to ensure safety and proper installation.
LED Parking Garage
Light
Wiring Diagram
LED Parking Garage Light
Page 1
Limited Warranty
The warranty applies to the product from the original date of purchase for five (5) years
against manufacturing defects. The owner must provide a copy of the original proof of
purchase. The manufacturer's obligation under this warranty is limited to repairing or
replacing the component. It is not related in any way to the cost of the connection, the
installation of the replacement parts or cost of transport.
Power Drill
Philips
Screwdriver
Tools Required
Do not modify this fixture. Any modifications may render the product unsafe and void warranty.
MAINTENANCE

Turn power OFF from electrical panel before installation or
maintenance.
WARNING
LED Parking Garage Light
Page 2
Installation Method
1. To remove the metal box cover, loosen the two screws using an Allen
Key, then slide horizontally the cover to remove it from hinges. Fig 2-1
2. Loosen the 3/4 plug on the driver box cover using a at screwdriver.
Fig. 2-2
3. Drill the holes on the ceiling accordingly to t the plate. Fig. 2-3
4. Insert the wires through the plug hole, and mount the cover on the
ceiling with screws. Fig.2-4
5. Slide the cover horizontally to attach it to the hinges. Fig. 2-5
6. Connect the input line and ground. If the xture is equipped with sensor,
adjust the sensor settings. Take relevant waterproof measures after the
wires are connected. Fig. 2-6
7. Close the box carefully not to cut any wires. Fig. 2-7
8. Tighten the two screws using an Allen key to secure the xture. Fig. 2-8