Nuie Ella ERCS0 User manual

A
BC
D
E
F
G
H
I
J
K
A HINGED PANEL 1
B FIXED PANEL 1
C MAGNETIC SEAL 1
D HINGE 2
E WALL POST 1
F COVER CAPS 6
G 10mm S.T SCREWS 3
H SCREW COLLARS 6
I 30mm SCREWS 3
J WALL PLUGS 3
K BOTTOM SEAL 1
L CHROME TRIM 1
M END CAP 1
HANDLE (ERCS1 ONLY) 1
NOT SHOWN
TOOLS REQUIRED
POWER DRILL
3.2 mm H.S DRILL
5mm MASONRY DRILL
POZI DRIVE SCREW DRIVER
SPIRIT LEVEL
1. LAY THE FIXED AND HINGED PANEL CURVED FACE
DOWN ON A PROTECTIVE SURFACE. DISASSEMBLE THE
HINGES AND FIX TO THE PANELS AS SHOWN.
2. PUT THE WALL POST ONTO THE FIXED PANEL,
WITH THE HELP OF ANOTHER PERSON PLACE IN
POSITION ON THE BATH. USING A SPIRIT LEVEL
MARK THE POSITION OF THE WALL POST ON
THE WALL WHERE IT WILL BE FIXED.
ELLA P HINGED BATH SCREEN FITTING INSTRUCTIONS
(ERCS0/ERCS1)
LM

3. REMOVE THE SCREEN AND WALL POST
FROM THE BATH, TAKE THE WALL POST AND
PUT BACK INTO POSITION, USING A SPIRIT
LEVEL TO ENSURE THAT THE POST IS PLUMB
MARK THE POSITION OF THE 3 FIXING HOLES.
4. REMOVE THE WALL POST AND DRILL
WHERE MARKED FOR THE WALL FIXINGS.
REPLACE THE WALL POST AND SECURE
INTO POSITION.
5.WITH THE HELP OF ANOTHER PERSON PLACE THE
ASSEMBLED SCREEN INTO POSITION . MARK THE
POSITIONS FOR THE 3 SIDE FIXINGS (SLIGHTLY OFFSET
FROM THE WALL FIXINGS SO YOU CAN FIX THE COVER
CAPS)ENSURE YOU DRILL THROUGH INTO THE FIRST
PART OF THE HOLLOW BOX SECTION OF THE ALUMINIUM
PROFILE ON THE FIXED SCREEN BEING CAREFUL NOT TO
GO THROUGH THE OTHER SIDE(DO NOT DRILL INTO THE
GLASS SECTION).DRILL THROUGH USING A 3.2 mm BIT
AND FIX USING THE 10mm SELF TAPPING SCREWS.
6. FIT THE MAGNETIC SEAL BY SPLITTING THE SEAL AND
ATTACHING TO THE VERTICAL SIDES OF THE FIXED AND
HINGED PANEL MAKING SURE TO TRIM AND NOTCH
OUT AROUND THE HINGES, THIS CAN BE DONE WITH
THE DOOR IN THE OPEN POSITION. FIT THE BOTTOM
SEAL AND BUTT THIS UP AGAINST MAGNETIC SEAL.
USING A SANITARY GRADE SILICONE SEALANT SEAL
DOWN THE WALL POST AND AROUND THE INSIDE AND
OUTSIDE AT THE BOTTOM OF THE FIXED PANEL. LEAVE
TO SET FOR 24 HOURS BEFORE USING THE BATH
SCREEN. FIT THE CHROME TRIM "L" AND END CAP "M"
TO THE TOP OF THE DOOR TO FINISH OFF.