Numark MALIBU S-700 User manual

MALIBU 40" ROUND
TEMPERED GLASS TOP TABLE
ASSEMBLY INSTRUCTIONS
ITEM# S-700
QUESTIONS, PROBLEMS, MISSING PARTS WITH THIS PRODUCT? DO NOT RETURN
TO YOUR RETAILER, PLEASE CALL OUR CUSTOMER SERVICE DEPARTMENT 9:00
A.M. TO 5:00 P.M. EASTERN STANDARD TIME MONDAY THROUGH FRIDAY PHONE#
1-800-229-0730

MALIBU 40" ROUND
TEMPERED GLASS TOP TABLE
ASSEMBLY INSTRUCTIONS
ITEM# S-700
1) Remove the table (which is shrink wrapped into one piece) from the box and place it
upside down on top of the carton box. Cut the shrink wrap open and count the
component pieces first. There are:
a) 1 tempered glass table top with rim (A)
b) 4 metal legs (B)
c) 1 accessory bag which consists of 2 center rings (Ca) with bolts, 1 spare bolt (Cb),
4 screws (Cc), 1 plastic umbrella insert piece (Cd), 1 Allen wrench (Ce), 1 spare
glass bumper (Cf), 1 assembly instructions sheet (Cg).
2) Remove all bolts that were attached
into each center ring (Ca). Insert
2 opposite metal legs (B) into the
plastic receivers on the table rim (A),
adjust the plastic receiver positions
by sliding them back and forth
where necessary. Place the lower
center ring (Ca) between two metal
legs, insert a bolt (Cb) through a
leg (B), and into the center ring for
each hole, do not tighten. Repeat
procedure for the upper center
ring (Ca). Insert the other two metal
legs (B) into the plastic receivers on
table rim, and repeat procedure.
3) Insert a screw (Cc) into each plastic receiver on the rim and into the leg. Tighten all
screws.
4) Tighten all bolts using Allen wrench (Ce). Turn the table over and place the plastic
umbrella insert piece (Cd) into center of the glass table umbrella hole, if not use
umbrella.
Your table is ready for use. NUMARK INDUSTRIES COMPANY LTD.,
PRINTED IN CHINA