Nuova Rade 196881 User manual

Installation Manual
Waste Water Tank
196881
Zefiro Tank waste
water 40lt Vertical
Zefiro Tank waste
water 60lt Vertical
196882
www.nuovarade.com
Installation scheme
Installation
Use and Maintenance
1
2
3
ZEFIRO
NUOVA RADE

Installation Scheme
Installation Example
The Zefiro tank is made from odour-free high density polyethylene (HDPE) and it is shaped in order to allow
effective discharge. It is compatible with diaphragm pumps and macerators (12 or 24 V) and it is supplied with:
When installation is carried out at more than 0.5 m above the waterline, the tank can be emptied without a
pump. And it can be mounted on a bulkhead. Accessories available for this product: sensor, gauge, vented
loop, ball valve, filter, deck filler.
1 inlet and 2 outlets Ø 38 mm-G 1 1/2”
1 vent Ø 25 mm-G ¾ “
1 inspection hatch: Ø127 mm
Plate compatible with VDO standard sensors
www.nuovarade.com
1
NUOVA RADE

1. Connectors tting
The thread of the compatible connectors can be found in the image as shown below.
The included and the optional connectors can be found in the following link:
Fitting Connectors included & optional
2. Sender assembly
The tank is supplied with a 5-holes ange (SAE-5 standard) to host a sender.
We recommend to always use the suitable gasket to assure a proper seal.
Hole for sensor
Rubber gasket included
Pre-installed screws
Warning! For a correct installation of the system, please refer to ISO 8099 Norm.
*Warning!
Any damages occurred during assembling process might compromise the correct operation of the tank.
Installation
www.nuovarade.com
2
NUOVA RADE

Zero waste water tank requires a correct use and maintenance in order to grant a correct and regular operation. Following, please note
some fundamental rules to be followed in the event of operation problems:
Make sure that the tank is regularly discharged to prevent overpressure. The tank has been studied and manufactured to support
a maximum pressure of 0,2 bar.
The tank must be installed allowing inspection and the maintenance of the accessories, pipe connections, pumps etc.
Make sure that the tank is empty and clean at the end of the season and before wintering. WARNING! Be sure that the gasket
is clean and intact before installing the sender. Nuts must be hand-screwed by using a wrench at a driving torque <
2Nm, so as to avoid irretrievable damages to the tank.
Use and Maintenance
www.nuovarade.com
3
NUOVA RADE