nuuk MC420 User manual

24in Outdoor
Stainless Steel
Working Table Cart
-Three Levels
Model: MC420
SKU: 40004
NUUK USA
3343 IVY FARM CT, BUFORD, GA 30519
nuukusa.com

Table of Contents
It is the consumer’s responsibility to see that the
unit is properly assembled, installed, and
maintained. Failure to follow the instructions in
the manual could result in bodily injury and/ or
property damage
Table of Contents - page 2
Safety Information - page 3
Customer Support - page 4
Care and Maintenance
Exploded View - page 5
Part List & Hardware - page 6
Assembly Instructions - page 7 – 11
Warranty - page 12
2

IMPORTANT: ALL INSTRUCTIONS AND
SAFEGUARDS IN THIS SECTION MUST BE
FOLLOWED TO PREVENT DAMAGE AND/OR
INJURY.
• Not for permanent installation.
• For outdoor use only
• Use caution with all electric appliances, tools,
extension cords and lights on and around table.
• Surface can become hot in direct sun or high
temperatures.
• Maximum top weight load of 100 LBS
• Maximum shelf weight load of 30 LBS
• Use only on level surfaces.
• Before use ensure wheels are height adjusted
so that the table does not rock when in use.
• Lock wheels when in use.
• Do not allow children to climb the product.
CALIFORNIA PROPOSITION 65 WARNING
WARNING: This product can expose you to lead, which
is known to the State of California to cause cancer and
birth defects or other reproductive harm. For more
information go to www.P65warnings.ca.gov
Safety Information
3

Customer Support
Care and Maintenance
HAVE PROBLEM / QUESTION/ CONCERN
NO WORRY!
Our Customer Service Staff is Here To Help You!
For questions regarding your NUUK products,
installation, replacement parts or your warranty,
please contact
NUUK customer service team.
Phone: [phone]
Monday through Friday
9:00 am to 5:00 pm, Eastern Time Zone
Email: [e-mail]
CLEANING
Painted and Plastic Surface
Wash with mild detergent or non-abrasive cleaner and
warm Water.
Stainless Steel Surface
Wash with mild detergent and warm soapy water or use
stainless steel cleaner. Wipe dry with a soft cloth after
each use.
Wash only in the direction of the stainless brushed nish
to avoid damage.
Stainless steel can rust under certain conditions. This
can be caused by acidic marinades, chlorine, saltwater,
exposure to coastal climates, other natural elements, or
improper cleaning tools such as wire or steel wool.
4

If you nd any missing parts, damage parts, please
contact NUUK
Phone: [phone]
Monday through Friday
09:00 am to 05:00 pm, Eastern Time Zone
Email: [e-mail]
5
Exploded View

Part sand Hardware List
6
PART DESCRIPTION QTY PART DESCRIPTION QTY
1
2
3
4
5
A
C
B
D
1
1
1
1
1
16
18
1
34
6
6
7
8
9
10
2
2
2
1
3
Mesh Shelf
Caster
Caster Wheel
Side Handle
"S" Hook
Counter Top
Left Back Leg
(LB)
Left FrontLeg
(LF)
Right Back Leg
(RB)
Right Front Leg
(RF)
Bolt
M6X15
Bolt
M6X45
Allen Wrench
Flat Washer
Step Screw

Assembly Instruction
CLEANING
Painted and Plastic Surface
Wash with mild detergent or non-abrasive cleaner and
warm Water.
Stainless Steel Surface
Wash with mild detergent and warm soapy water or use
stainless steel cleaner. Wipe dry with a soft cloth after
each use.
Wash only in the direction of the stainless brushed nish
to avoid damage.
Stainless steel can rust under certain conditions. This
can be caused by acidic marinades, chlorine, saltwater,
exposure to coastal climates, other natural elements, or
improper cleaning tools such as wire or steel wool.
PREPARATION
Please be careful when handling components. Always
wear gloves during assembly and set up. Read and follow
all safety statements, warning, assembly instructions and
use care instructions before attempting to assemble and
use. Before beginning assembly of product, make sure all
parts are present. Compare parts with package contents
listing and hardware contents list. If any part is missing
or damaged, DO NOT attempt to assemble the product.
ASSEMBLY TIP
To avoid scratching counter top and to protect oor/patio
surface, reuse cardboard packaging and lay parts on top
while assembling
STEP 1
Install locking caster wheel (8) to right back leg (4) and
right front leg (5).
Install unlocking caster (7) to left back leg (2) and left
front leg (3)
7

Assembly Instruction
STEP 2
Install left front leg (LF) (3) and left back leg (LB) (2)
to left side of counter top (1), use Eight (8) M6X15-A &
Eight (8) Flat Washer-B.
STEP 3
Install right front leg (RF) (5) and right back leg (RB)
(4) to right side of counter top (1), use Eight (8)
M6X15-A & Eight (8) Flat Washer-B.
Logo located at left side
of counter top
NOTE:
It is important to not fully
tighten the screws during
initial assembly of parts.
Wait until the 2nd mesh shelf
is installed before fully
tighten all screws on the cart
8

Assembly Instruction
STEP 4
Install mesh shelf (6) to mid of four legs, use Eight (8)
M6X45-C & Eight (8) Flat Washer-B.
9
STEP 5
Install mesh shelf (6) to end of four legs, use Eight (8)
M6X45-C & Eight (8) Flat Washer-B.

Assembly Instruction
STEP 6
Install side handle (9) to right side leg, use Two (2)
M6X45-C & Two (2) Flat Washer-B.
10
STEP 7
Install the three step screws (D) to each side of
counter top.
Put the “S” hook (10) on side handle.

Assembly Instruction
Finished Products
Once the nish cart moved to the desired location,
adjust the caster wheel to t the uneven oor
11

Warranty
NUUK LLC (NUUK USA)
1-YEAR WARRANTY
PROOF OF PURCHASE is required to access this
warranty program, which is in effect from the date of
purchase.
NUUK USA warranty covers one year from the date of
purchase. NUUK will assist you to get the replacement
parts, replace the unit. All warranties are limited to the
original purchase only. This warranty does not cover any
liability for used good purchase. The purchaser must
follow the usage instruction.
Warranty Provisions
• This warranty is non-transferable and does not cover
failure due to misuse, improper installation or
maintenance.
• This warranty is for replacement of defective parts
only. We are not responsible for incidental or
consequential damages or labor costs.
• This warranty does not cover damage caused by
abrasive or chemical cleaners, or any damage to other
components used in the installation or operation of the
table.
• Paint is not warranted and may require touch-up.
For replacement parts, and assistance need, please
contact us:
Phone: [phone]
Monday through Friday
09:00 am to 05:00 pm, Eastern Time Zone
Email: [e-mail]
12