07
6. USING THE NZXT LIFT MOUSE WITH CAM SOFTWARE
A. DOWNLOADING AND INSTALLING CAM SOFTWARE
Go to nzxt.com/software/cam for the latest version of CAM
B. SETUP OF CAM PROFILES AND STORING ON THE KEYBOARD
The Lift Mouse has four onboard profiles that can be setup and stored via
CAM software. After profile information is stored, it is not necessary to run
CAM to operate stored lighting, macros, etc.
C. CONTROLLING PROFILE SWITCHING
Depressing the DPI button for one to three seconds (long press) will
change to the next stored profile (1 through 4, respectively).
D. LIGHTING MODES
There are four default lighting modes stored on profiles #1 through #4 and
can be cycled through by a long press of the DPI button.
E. CUSTOMIZING RGB LIGHTING
By using CAM/Mouse/Lighting, users are able to customize lighting, and
set up lighting under profiles (if desired), as described in SECTION B.
F. CUSTOMIZING KEYBOARD MACROS
By using CAM/Mouse/Macros, users are able to create both simple and
complex macros, and store them under profiles (if desired), as described in
SECTION B.
G. REBINDING KEYS
By using CAM/Mouse/Key Remapping, users are able to create new and
customized button bindings, and store them under profiles (if desired), as
described in SECTION B.
