O'jump 699 User manual

18/01/2021
1
(UK) Assembly Instructions
BUCK
Ref. : 99
N°29

18/01/2021
2
Thank you for buying this product O'jump. We advise you to read the assembly instructions
carefully. The apparatus is presented in pre-assembled parts for a simplified assembly. We
have designed this O'jump product to bring you complete satisfaction. If you need help, the
O'jump team is at your disposal to accompany you .
Warning:
This equipment must only be used by one person at a time and under the supervision of a
qualified individual, with appropriate landing mats.
Using this equipment for purposes other than those originally intended is prohibited.
Risk of injury from sudden fall of apparatus.
To avoid the apparatus tumble, the apparatus must fixed to the ground permanently.
The fixations are not included because their choice depending the ground material. Use the
appropriate fixation according the support. To get advices or fixations sets contact the
O’JUMP department.
Recommendations:
- keep these instructions for subsequent reference (inspection, maintenance, etc.).
- periodically carry out predictive maintenance.
- depending on how much it is used, have the equipment serviced yearly or every few years.
Footprint and eight:
- Apparatus 80 x 0 x 100 cm (Lxlxh)
35Kg

18/01/2021
3
Tools needed to assemble the apparatus.
14/18/19
Hardware listing (pre-assembled)
M12 lifting
ring
X1
Ø8
Quick link
X3
M12
T
urnbuckle lantern
eye
-
eye
X1
Chain
with
20 links Ø8 length 50 cm
X1
Indexing knob
X4
A
B
C
D
E

18/01/2021
4
List of parts (pre-assembled)
Legs
Body
Groudn anchoring
system

18/01/2021
5
Warning :
Safety is always the main consideration when setting up an apparatus.
• It is important to always have a good understanding of the task.
• Use common sense.
. Always hold the foot with one hand when unscrewing the knobs
. Risk of injury from sudden fall of the foot.
Height adjustment
Unscrew
and pull
the indexing knob
to
release the slide.
Slide up or down the foot. Release the
knob in front of the desired position.
Lock the knob by tightening.
Repeat for all four feet.
View A by transparency
A
Note: adjustment holes in 5cm steps

18/01/2021
Assembling the anchoring system to the ground
To increase the stability, the buck is delivered with a ground anchring system.
B
D
B
C
B
Place the
body directly above the anchor
point.
Tighten the lantern tensioner
locknuts with a wrench.
18/19
Tightening torque of the links 3Nm.
14

18/01/2021
7
Ground anchor
Material required :
Check with the O’JUMP service specifying the nature of your s
upp
ort
. The type of plugs and screws
depending on whether your floor is concrete, wooden floor, flexible ground...
1.
Wi
th
a pencil, trace the location of the hole in line with the anchoring system.
A bubble
level
A drill
A
nchors
adapted
to
your support
Screws
a
dapted
to
your support
Wrench adapted to
your type of screws
Pencil

18/01/2021
8
2
.
Drill all the holes using a drill bit
appropriate
for your floor. Place the
fixation
s in the holes.
They should not be higher than the ground.
3
.
Put
in p
la
ce
a
n
anchor ring
(not supplied).