O'jump 950 User manual

01/09/2020
1
(UK) Assembly Instructions
FREESTYLE TRAINING BARS
Réf : 950
N°297

01/09/2020
2
Thank you for buying this product O'jump. We advise you to read the assembly instructions
carefully. The apparatus is presented in pre-assembled parts for a simplified assembly. We
have designed this O'jump product to bring you complete satisfaction. If you need help, the
O'jump team is at your disposal to accompany you.
Warning:
This equipment must be used by only one person at a time and under the supervision of a
qualified person, with appropriate receiving mats.
The use of this equipment for purposes other than those initially provided for is excluded.
Recommendations:
It is recommended as stated in the French standard NF S52-400 from:
- keep this notice for future reference (inspection, maintenance, etc.).
- perform periodic predictive maintenance.
- establish an annual or multi-year audit depending on the use.
Footprint and weight:
- Apparatus 3.50 x 3.50 m 123 Kg

01/09/2020
3
Tools needed to assemble the apparatus.
Hardware listing (pre-assembled)
indexing handle
X8
X8
Index finger
X24
M10 x 60
A
Ø22x10.5
B
X48
X24
M10
C
Hex wrench N°18/19

01/09/2020
4
List of parts (pre-assembled)
Central post (1 package)
X1
Side post (4 packages)
X4
X2
X2
Ø28 steel hand rail
(2 packages)
Ø40 wooden hand-rail
(2 packages)

01/09/2020
5
Assembling the hand rail
A
B
A
B
To insert the pin, press the blue
button to release the ball.

01/09/2020
6
Hand rail height adjustment
Unscrew the knobs. Pull on the indexing knobs
to release the slide.
Slide it down or up. Release the knob in front
of the desired position. Lock the two knobs by
tightening. (See photo page 7)
Repeat for all four posts.
Warning :
Safety is always the main consideration when setting up an event.
• It is important to always have a good understanding of the task.
• Use common sense.
. Always hold the slide with one hand when unscrewing the knobs
. Risk of injury from sudden fall of the guide rail.

01/09/2020
7

01/09/2020
8
Fixing the freestyle training bar to the ground
Material required :
Check with the O’JUMP service specifying the nature of your soil. The type of plugs and screws varies
depending on whether your floor is concrete, parquet, taraflex...
1. Put the hand rail in the lower position and adjust the plumbing of the uprights with the
bubble level.
A bubble level
A drill
anchors adapted to
your soil
Screws adapted to
your soil
Wrench adapted to
your type of screws
Pencil

01/09/2020
9
Cutaway top view
2. Using a pencil, trace the location of the 6 holes.
Position the side post and ensure the
correct alignment of the hand-rail using
the above ribs.
1861

01/09/2020
10
3. Drill all the holes using a drill bit suitable for your floor. Place the dowels in the holes. They
should not protrude from the ground.
4. Position the uprights opposite the holes, then secure the uprights with suitable screws.