O'jump 690 User manual

18/01/2021
1
(UK) Assembly Instructions
PE HIGH BAR
Re . : 690
N°294

18/01/2021
2
Thank you or buying this product O'jump. We advise you to read the assembly instructions
care ully. The apparatus is presented in pre-assembled parts or a simpli ied assembly. We
have designed this O'jump product to bring you complete satis action. I you need help, the
O'jump team is at your disposal to accompany you.
Warning:
This equipment must only be used by one person at a time and under the supervision o a
quali ied individual, with appropriate landing mats.
Using this equipment or purposes other than those originally intended is prohibited.
Risk of injury from sudden fall of apparatus.
To avoid the apparatus tumble, the apparatus must fixed to the ground permanently.
The ixations are not included because their choice depending the ground material. Use the
appropriate ixation according the support. To get advices or ixations sets contact the
O’JUMP department.
Recommendations:
- keep these instructions or subsequent re erence (inspection, maintenance, etc.).
- periodically carry out predictive maintenance.
- depending on how much it is used, have the equipment serviced yearly or every ew years.
Footprint and eight:
- Apparatus 280x25cm (Lxl) poids 47Kg

18/01/2021
3
Tools needed to assemble the apparatus .
Hardware listing (pre-assembled)
indexing knob
X2
X2
Index
ing
pin
Tightening knob
X2

18/01/2021
4
List o parts (pre-assembled)
High bar
uprights
(2
packages
)
X2
X1
Steel hand
-
rail +
Steel tube
(1
package
)
X1

18/01/2021
5
To
insert the
indexing
pin, press the
blue button to release the ball.
A
A

18/01/2021
6
Unscrew the
tightening and indexing
knobs. Pull the indexing knob to
release the slide.
Slide it down or up. Release the
indexing knob in ront o the desired
position. Lock the two knobs by
tightening.
Warning:
Sa ety is always the main consideration when setting up an apparatus.
• It is important to always have a good understanding o the task.
• Use common sense.
. Always hold the slide with one hand when unscrewing the knobs
. Risk o injury rom sudden all o the slide
Height adjustment

18/01/2021
7
Fixing the high bar to the ground
Material required :
A
bubble
level
A drill
anchors adapted to
your support
Screws adapted to
your support
Wrench adapted to
your type o screws
Pencil
Check with the O’JUMP service speci ying the nature o your
support
. The type o
anchors
and screws
depending on whether your loor is concrete, wooden loor, lexible ground...
1.
Put the hand
-
rail in the low position and adjust the
verticality
o
the uprights with the bubble level
.
Check the correct alignment o the uprights.

18/01/2021
8
2
.
With
a pencil, trace the location o the 4 holes or each plate.
(Do not use the middle holes)
3.
Drill all the holes using a drill bit
appropriate
or your loor. Place the
ixation
s in the holes.
They should not be higher than the ground.

18/01/2021
9
4.
P
ut in place
the uprights
in ront o
the
4
holes, then
ix
the uprights with
appropriate
screws.