Occasions INFLATABLE YELLOW LAB User manual

Failure to follow all instructions listed below, may result in electric shock,
fire and /or serious personal injury.
WARNING: ELECTRIC PRODUCT – Keep away from children. Not recom-
mended for children under 3 years of age. As with all electrical products,
precautions should be observed during handling and use to reduce the
risk of electric shock. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Adults Note: Periodically examine this product for damage to the cord,
housing or other parts that may result in the risk of fire, electric shock or
injury. If the product is damaged, do not use it
DANGER – To prevent electric shock, do not immerse in water; wipe clean
with damp cloth. Immersing this product can result in an electric shock.
WARNING: READ AND UNDERSTAND
ALL INSTRUCTIONS
Inflatable
YELLOW
LAB

When using electrical products, basic
precautions should always be followed,
including the following:
• This is an electrical product – not a toy! To
avoid risk of fire, burns, personal injury, and
electric shock, it should not be played with
or placed where small children can reach it.
• Do not use seasonal products outdoors
unless marked suitable for indoor and
outdoor use. When products are used in
outdoor applications, connect the product to
a Ground Fault Circuit Interrupting (GFCI)
outlet. If one is not provided, contact a
qualified electrician for proper installation.
• This seasonal use product is not intended
for permanent installation or use.
• Do not mount or place near gas or electric
heaters, fireplaces, candles, or other similar
sources of heat.
• Do not secure product wiring with staples or
nails or place on sharp hooks or nails.
• Do not let lamps rest on the supply cord or
on any wire.
• Unplug the product when leaving the house,
when retiring for the night, or if left
unattended.
• Do not use this product for other than its
intended purpose.
• Do not hang ornaments or other objects
from cord, wire, or light string.
• Do not close doors or windows on the
product, or extension cords, as this may
damage the wire insulation.
• Do not cover the product with a cloth, paper,
or any material not part of the product when
in use.
• Do not place the product against carpeting,
furniture, or any other fabric when in use.
• This product has a polarized plug (one blade
is wider than the other) as a feature to
reduce the risk of electric shock. This plug
will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If the plug still does not fit,
contact a qualified electrician. Do not use an
extension cord unless the plug can be fully
inserted. Do not alter or replace the plug.
• This product employs overload protection
(fuse). A blown fuse indicates an overload or
a short-circuit situation. If the fuse blows,
unplug the product from the outlet. Also
unplug any additional string or products that
may be attached to the product. Replace the
fuse as per the user servicing instructions
(follow product markings for proper fuse
rating) and check the product. If the
replacement fuse blows, a short circuit may
be present and the product should be
discarded.
• Before using and reusing, inspect the
product carefully. Discard any products that
have cut, damaged or frayed wire insulation
cords, cracks, lamp holders or enclosures,
loose connections, or exposed copper wire.
• Read and follow all instructions that are on
the product or provided with the product.
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS

• Before using and reusing, inspect the
product carefully. Discard any products that
have cut, damaged of frayed wire insulation
cords, cracks, lamp holders or enclosures,
loose connection, or exposed copper wire.
SAVE THESE INSTRUCTIONS
USE AND CARE INSTRUCTIONS
1 x Inflatable
1 x Air blower
(Input: 120V AC 0.54A ~ 60Hz)
4 x Tethers
8 x Tether Stakes
2 x Air blower stakes
1 x Extra Fuse (5amp, 125V)
1 x Extra Lamp (C-7 lamp, 7W)
• When storing the product, carefully removed
the product from wherever it is placed,
including trees, branches, or bushes, to
avoid any undue strain or stress on the
product conductors, connections and wires.
• When not in use, store neatly in a cool, dry
location protected from sunlight.
PART LIST (MODEL NO.:120V540-49305)
P.3 49305

SETUP INSTRUCTIONS
1.
3.
4.
1. Remove contents from packaging. Lay
out deflated inflatable on a clear and flat
area with the feet of the fan touching the
ground.
Remove all plastic fasteners and tags.
These are part of the packaging and
should be discarded.
2. Zip up the zipper into the closed position,
inflatable will then fully inflate.
Locate the staking holes on the bottom
of the Air blower and insert the Air
blower stakes through the holes and into
the ground.
3. Plug into receptacle or other outlet
device to inflate your inflatable. NOTE:
complete inflation may take a few
minutes.
4. Once fully inflated, locate the Nylon
Loops on the bottom of the fabric base
and insert the spiral stakes through the
Nylon loops and into the ground.
CAUTION:
1. For even better nighttime illumination, you may choose to place an outdoor approved
spotlight in front of your inflatable. (Outdoor approved spotlight not provided). Do not
place the bulb too close to the inflatable as it may melt or damage the plastic.
2. Do not place any foreign objects inside your inflatable.
3. Do not block air intake area located on the base of your inflatable, it will decrease the
inflation time.
4. During inclement weather conditions such as heavy rains, snow and windstorms, store
the product indoors
5. Operation of your inflatable during extreme weather conditions is not recommended.
6. Do not store the inflatable when it is wet.
4
.
2.
P.4 49305

USER SERVICING INSTRUCTION
Replace the fuse:
1. Grasp plug and remove from the receptacle
or other outlet device. Do not unplug by
pulling on the cord.
2. Open the fuse cover. Slide opens the fuse
access cover on top of the attachment plug
towards blades. (See Illustration)
3. Remove fuse carefully.
4. Risk of fire: Replace fuse only with 5 Amp,
125V fuse (provided with product)
5. Close the fuse cover. Slide closed the fuse
access cover on top of the attachment plug.
6. Risk of Fire: Do not replace the attachment
plug. Contains a safety device (fuse) that
should not be removed. Discard product if
attachment plug is damaged.
Lamp Replacement:
1. Grasp plug and remove from receptacle or
other outlet device. Do not unplug by pulling
on the cord.
2. Open the zipper.
3. Open the protective light cover carefully by
pressing down on the two locking side tabs
simultaneously.
4. Unscrew lamp counter-clockwise.
5. Replace lamp with only same type of lamp:
C-7 lamp (one piece replacement lamp
provided) 120V, 7W maximum, candelabra
base and UL classified.
6. Do not over-tighten the lamp as this may
damage the lamp or lamp-holder.
7. Be sure all zippers on characters should be
completely closed before inflate operation
so that air does not escape.
CAUTION: Disconnect the lighting string or
decorative outfit from the outlet before
removing a lamp and replacing it with the
ornament.
CAUTION: Replace only with same type 7
Watt Max candelabra-base UL-Classified
lamps.
CAUTION: Replace only with same type C7,
Watt Max 7W UL Classified lamps.
CAUTION: To reduce the risk of fire do not
deliberately reposition either lamp holder
contact.
CAUTION: Do not attempt to inflate your
inflatable during unusually strong winds. If it
becomes too windy for safe operation, simply
allow your inflatable to deflate and wait for
better conditions before re-inflating.
CAUTION: Protect the electric fan and power
cord from direct exposure to water. This
precaution will reduce the risk of electrical
shock. When the temperature is below 14˚F
(-10˚C), the motor may temporarily stop
running. The motor will begin functioning again
in higher temperatures.
CAUTION: To reduce the risk of fire or electric
shock, do not attempt to replace lamps or
modify string.
49305 P.5

TROUBLE SHOOTING CHECKLIST
IF YOUR INFLATABLE IS NOT
INFLATING, THE PROBLEM MAY
BE:
• The power source is disabled or
the cord may be unplugged.
• Debris may be lodged in the motor.
NOTE: Periodically, the inflatable
air-intake area may become
clogged with grass, leaves or other
debris. For best results, it is recom-
mended to check this air-intake
area and clean as necessary.
• Occasionally, the hanging fabric of
a partially-inflated inflatable can
become attached to the Motor’s
air- intake area. Ensure that fabric
is not hanging near the motor
during inflation.
• The zippers which seal the inflat-
able may not be securely closed.
• The connection between the
inflatable and fan may not be
securely attached.
PLEASE RETAIN THIS INFORMATION
FOR FUTURE REFERENCE.
COLORS AND CONTENTS MAY VARY
LOS ANGELES, CA 90064.
ALL RIGHTS RESERVED
MADE IN CHINA
For questions or problems with this product please email
[e-mail] for expedited assistance or
call 1-800-434-6178.