7
8
1
www.OceanSonics.com
Step 3: Connect power adaptor to test cable
(small black connectors) You will hear a single
buzz, and then 10-30 seconds later you will
hear a double buzz, which means it’s ready.
Step 4: Plug test cable (black Ethernet) into
PC until it clicks.
Step 5: Plug USB drive into PC and install
Lucy Software.
Step 6: Run Lucy Software to locate & connect
to your icListen. (Open Lucy and click icListen
in the bottom right corner)
Step 8: Open Webserver.
7
6
64
7
4
7
2
Step 7: Select the Link Setup Tab at the top then
select Ethernet and click Find All Units. Double
click your unit when it appears, to connect.
Step 1: Connect power cord (6)
to power adapter (4) and plug
into the wall.
Step 2: Plug test cable into icListen. (Fully
lubricate the connector with the supplied
Molykote M44) (8). For videos on how to
lubricate properly, please visit -
macartney.com/support
