Office Boffins COREM001 User manual

ASSEMBLY
INSTRUCTIONS
A-1 PC
E-1 PC
D-1 PC
F-2 PCS
B-5 PCS
I-1 PC
C-1 PC
G-6 PCS
M6×35mm
PRE-INSERTED
H-6 PCS
D6×D14×1.2mm
PRE-INSERTED
PLEASE NOTE:
The screws “G” and part “H” are pre-inserted into their correct holes to prevent
them from being lost in transit. Please remove them before assembly using the
allen key provided.
COREM001
RL

4
3
21
2
Do not tighten bolts fully until you have completed assembly.
DO NOT USE A POWER DRILL TO TIGHTEN THE SCREWS.
TIGHTEN BY HAND WITH THE ALLEN KEY PROVIDED.
DONOTSTANDONTHISCHAIR.
DONOTUSETHISCHAIRASASTEPLADDER.
USETHISPRODUCTFORSEATINGONEPERSONATATIMEONLY.
DONOTUSETHISCHAIRUNLESSALLBOLTS,SCREWSANDKNOBSAREFIRMLYSECURED.
ATLEASTEVERY6MONTHS,CHECKALLBOLTS,SCREWSANDKNOBSTOBESURETHEYARETIGHT.
IFPARTSAREMISSING,BROKEN,DAMAGEDORWORN,STOPUSINGTHISPRODUCTUNTILREPAIRSAREMADEUSINGFACTORYAUTHORISEDPARTS.
FAILURETOFOLLOWTHESEWARNINGSCOULDRESULTINSERIOUSINJURY.
WARNING
B×5
E
A
G×3
G×3 H×3
C
D
H×3
FR
FL

3
45° adjustmentHeight adjustable headrest
Height adjustable arms Sliding arm pads Pivong arm pads
Height adjustable backrest
Weight Tension Adjustment, turnSeat Height Adjustment, li handle Seat Depth Adjustment, push lever
to raise / lower seat height. down to adjust seat depth. clockwise to increase resistance,
an-clockwise to decrease.

4
Seat Angle Adjustment, turn clockwise to Synchronised Tilt Adjustment, push handle
posion. (approximately 5 degree lt).
release, lt seat pad forward then turn
an-clockwise to lock into the pre-set
down to release lt, li handle up to lock in
poson.
2 Posion Back Angle Tilt, pull the lever out to release the
posion. Pull out again to lean back into the 2nd posion.
back angle lt. Pull out once and lean back into the 1st