Okina USA SIVD10H-755AI Quick start guide

Copyright © 2009. All Rights Reserved. P = PAL Version
www.okinausa.com Rev093009
Operational Manual
3-AXIS Day & Night
Vandal Proof IR Dome Camera
z1/3” Sony Super HAD CCD
z550 TV Lines, HQ-1 DSP
z10 High Power IR LED
z2.9mm~10.0mm Aspherical Auto Iris Lens
Made in Japan
zMechanical IR Cut Filter Removable (ICR)
zHigh Gain/Low Noise Amplifier - DNR
zIR Distance up to 50ft / 15m
z0 Lux IR “on” @ 2.0 Lux
zPower Consumption 224mA @ IR “off” / 355mA @ IR “on”
zIP66 Rating
z12V DC
To mount the camera directly on the ceiling:
(1). Drill ф25mm hole on the ceiling for video and power
connector cable to pass through.
(2). Take off the dome cover from the camera. Use specified
holes inside the camera base for installation.
(3). Fasten the camera base on the ceiling with the 3 screws
that are provided.
FEATURES
Please read the Operational Manual
before attempting to use this product.
INSTALLATION
DIMEN
S
I
O
N
S
(U
ni
t
: mm
)
3-AXIS
SIVD10H-755AI
SIVD10H-755AIP

Copyright © 2009. All Rights Reserved. P = PAL Version
www.okinausa.com Rev093009
(4). Adjust pan, tilt, and rotation until the image is satisfied.
After adjusting the camera, put the cover back on.
1. FAR/NEAR
2. WIDE/TELE
3. DC LEVEL
The VR for adjusting the IRIS level of Auto Iris lens.
4. CONTROL SWITCHES
Switch 1. AES: Automatic Electronic Shutter.
AES / OFF switch.
The range of shutter speed from 1/60 (1/50sec.) to
1/100,000 sec.. This mode is employed for using a
manual iris lens.
OFF: AES OFF.
The shutter speed is 1/60sec.
(1/50sec.).
When an auto iris lens is applied, AES should
be off.
Switch 2. BLC: Backlight Compensation.
BLC / OFF switch.
When the object is dark by strong light (sunlight
etc….) as (Fig.2-1), please turn on BLC to make
object become bright as (Fig.2-2).
OFF: BLC OFF.
Switch 3. AGC: Automatic Gain Control.
AGC / OFF switch.
AGC level of gain varies from 0 to 26dB.
OFF: AGC OFF. The level of gain is fixed at 0dB.
Switch 4. FL: Flickerless.
F. L / N O M s w i t c h .
In FL mode, the shutter speed is 1/100sec. (NTSC
system) / 1/120sec. (PAL).
If choose FL mode, [AES] switch should be off.
NOM: Normal position.
PARTS
A
ND FUNCTIONS

Copyright © 2009. All Rights Reserved. P = PAL Version
www.okinausa.com Rev093009
5. Video connector
This is an output for connection to a video monitor, etc (75Ω).
6. Power input terminal
Connect to 12V DC power supply.
*Specifications are subject to change without notice
zOne (1) SIVD10H-755AI/SIVD10H-755AIP Camera with
video/power cable
zOne (1) L-type Star Wrench
zOne (1) L-type Hexagon Wrench
zThree (3) Wall Anchors
zThree (3) Mounting Screws
zOne (1) Operational Manual
*For any returns, please include all components listed above
with original packaging in Resalable Condition. Absolutely
No Returns will be accepted if any component is
missing/damaged or if any cable is cut or tampered with.
1. Never point the camera toward the sun
Do not expose the lens directly to the sun or to strong light as
this may damage the pick-up device.
2. Handle this camera with care
Avoid any shock or bumping of the camera. Improper handling
could damage the camera.
3. Requires a proper operating environment
This camera is designed for outdoor or indoor use. The
allowable temperature range for operation of this camera is
between 14°F ~ 122°F / -10oC ~ +50oC and the allowable
humidity is 85% RH maximum.
4. Clean the front face to the pick-up device
It is recommended that the pick-up device surface be cleaned
before lens installation or whenever the lens is changed.
Cleaning should be done by using a chamois, a very fine soft
cloth, lens tissue, or cotton tipped applicator and ethanol to
carefully remove any fingerprint or dust.
5. Check the power source voltage
The power source voltage should be within the specified
range. (Camera must meet the specifications). Camera must
be connected to a surge protector at all times.
6. Objects and liquid entry
Never push objects of any kind into this camera as this may
touch dangerous voltage points of short out parts that could
result in a fire or electric shock. Never spill any kind of liquid
on the video product.
7. Servicing
Do not attempt to service this video product by yourself as
opening or removing covers may expose you to dangerous
voltage or other hazards. Refer all service to qualified
servicing personnel.
8. Damage requiring service
Unplug this video product from the wall outlet and refer
service to qualified servicing personnel under the following
conditions:
a. When the power supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the
video product.
c. If the video product has been dropped or the cabinet
has been damaged.
d. When the video product exhibits a distinct change in
performance.
OKINA USA products are covered under warranty for one year
from the date of purchase. The warranty will automatically be
voided if any of the following occurs:
1. Camera sticker is removed
If the camera sticker is removed, we will not be able to
confirm any information regarding when and where the
product was purchased. We have no other way to verify the
purchase record without the serial number on the camera
sticker; therefore, it should not be removed.
2.
Camera is modified in any way
If the camera is scratched, damaged, or modified in a manner
not described in this manual, the warranty will be voided
immediately. It is the customer’s responsibility to keep the
camera in good condition.
3. Video or power cable is cut
The video cable and the power cable should not be tampered
with. Cutting or modifying of the cables will result in
termination of the warranty.
Model SIVD10H-755AI SIVD10H-755AIP
TV System NTSC PAL
Image Sensor 1/3” Sony Super HAD CCD
DSP Sony HQ-1
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Synchronizing
System Internal
Resolution 550 TV Lines
Minimum
Illumination 0 Lux IR LED “on” @ 2.0 Lux Controlled by a CDS sensor
Day/Night Switching Mechanical IR Cut Filter
DNR / Sens-up High Gain/Low Noise Amplifier - DNR
IR LEDs 10 High Power IR LED
IR Distance Up to 50ft / 15m
S/N Ratio More than 50dB (AGC OFF)
Auto Gain Control ON / OFF (switchable)
Flickerless ON / OFF (Switchable)
BLC ON / OFF (Switchable)
AES ON / OFF (Switchable)
DC Level
T
he VR for adjusting the IRIS level of auto
Iris lens
White Balance AWB
Video Output 1Vp-p composite / 75 Ohms
Lens /
Angle of View
2.9mm~10.0mm / F1.2
Aspherical Auto Iris Lens 94.6°~28.8°
Made in Japan
Lead Free Yes
Waterproof Level IP66
Power Supply 12V DC
Power Consumption 224mA @ IR “off” / 355mA @ IR “on”
2.7W @ IR “off” / 4.3W @ IR “on”
Operating
Temperature 14°F ~ 122°F / -10oC ~ +50oC
Dimension 5.51”(dia) x 4.41”(H)
140(dia) x 112(H) mm
Weight 2.09 lbs / 950g
CAUTION
WARRANTY
SPECIFICATIONS
LIST OF COMPONENTS