Okina SHM-7550DNP Quick start guide

SHM-7550DN_rev04292008
Operational Manual
True Day & Night MICF Camera
1/3” Sony Super HAD CCD
550 TV Lines, HQ-1 DSP
0.15 Lux @ F1.0
Mechanical IR Cut Filter (ICR): As the amount of illumination
decreases, the Mechanical IR Cut Filter automatically switches to
B/W mode to increase light sensitivity for a brighter image. After
illumination regains brightness, the Mechanical IR Cut Filter will
automatically switch from B/W mode to color mode.
Lead (Pb) Free RoHS Compliance
Relatively no interference from magnetic or electrostatic fields.
Dual Power 12V DC / 24V AC
Night/IR Mode
Day Time Mode
(
<4 Lux
)
(
>7 Lux
)
1. Lens mount
This mount is used to install a CS-mount lens.
CS-adaptor ring is required if use a C mount lens.
2. Camera mounting screw holes
Screw hole for fixing camera.
3. Mount Adaptor
This adaptor can be attached to either the top or bottom of the unit.
4. Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto iris lens (not supplied) with DC
power and a video signal or DC control signal.
PIN NO. VIDEO DC
1 DC + 12V CONTROL -
2 NC CONTROL +
3 VIDEO SIGNAL DRIVE +
4 GND DRIVE -
5. Control Switch
SW1. SYNC MODE: SYNC Mode Selection INT/L.L. switch.
SW2. AES: Automatic Electronic Shutter OFF/AES switch.
SW3. BLC: Back Light Compensation OFF/BLC switch.
SW4. F.L: Flickerless NOM/F.L switch.
SW5. AGC: Automatic Gain Control OFF/AGC switch.
6. VIDEO connector
This is an output for connection to a video monitor, etc (75ohms).
7. Iris mode selection switch
Used to choose DC or VIDEO mode according to the type of your lens.
8. DC Level adjustment V.R.
Used to adjust video output level of DC driven auto iris lens.
9. Power input terminal
Connect the power supply of 12V DC / 24V AC.
SHM-7550DN
SHM
-
755
0
DNP
FEATURES
NOMENCLATURE AND FUNCTION
Please read the Operational Manual
before attempting to use this product.
DIMENSIONS (Unit: mm)

SHM-7550DN_rev04292008
SW1. SYNC MODE: INT MODE: The camera may be operated
independently with its internal crystal control. L.L. MODE: This version
w/o L.L. function.
SW2. A.E.S. (Auto Electronic Shutter): AES: The automatic electronic
shutter control 1/60(1/50) ~ 1/100.000 sec. is employed for using a
manual Iris Lens.
SW3. Example of B.L.C. (Back Light Compensation): When the
object is dark by strong light (sun illumination etc) as (Fig 3-1). Please
turn on BLC switch. The object becomes as (Fig 3-2).
SW4. F.L. (Flickerless): F.L: Fixes shutter speed at NTSC: 1/100 Sec.;
PAL: 1/120 Sec. When using this switch, set “AES” OFF. NOM: Normal
position.
SW5. A.G.C. (Auto Gain Control): AGC: level varies from 0 to 26dB.
OFF: AGC level is fixed at 0 dB.
*Specifications are subject to change without notice
One (1) SHM-7550DN/SHM-7550DNP Camera
One (1) Allen Wrench
One (1) CS Adaptor Ring
One (1) Auto Iris Lens Connector
One (1) Operational Manual
*For any returns, please include all components listed above with original
packaging in Resalable Condition. Absolutely No Returns will be
accepted if any component is missing/damaged or if any cable is cut or
tampered with.
1. Never point the camera toward the sun
Do not expose the lens directly to the sun or to strong light as this may
damage the pick-up device.
2. Handle this camera with care
Avoid any shock or bumping of the camera. Improper handling could
damage the camera.
3. Requires a proper operating environment
This camera is designed for indoor use. The allowable temperature range
for operation of this camera is between -10C ~ 50C and the allowable
humidity is 85%RH maximum.
4. Clean the front face to the pick-up device
It is recommended that the pick-up device surface be cleaned before lens
installation or whenever the lens is changed. Cleaning should be done by
using a chamois, a very fine soft cloth, lens tissue, or cotton tipped
applicator and ethanol to carefully remove any fingerprint or dust.
5. Check the power source voltage
The power source voltage should be within the specified range. (Camera
must meet the specifications). Camera must be connected to a surge
protector at all times.
6. Objects and liquid entry
Never push objects of any kind into this camera as this may touch
dangerous voltage points of short out parts that could result in a fire or
electric shock. Never spill any kind of liquid on the video product.
7. Servicing
Do not attempt to service this video product by yourself as opening or
removing covers may expose you to dangerous voltage or other hazards.
Refer all service to qualified servicing personnel.
8. Damage requiring service
Unplug this video product from the wall outlet and refer service to
qualified servicing personnel under the following conditions:
a. When the power supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the video
product.
c. If the video product has been exposed to rain or water.
d. If the video product has been dropped or the cabinet has been
damaged.
e. When the video product exhibits a distinct change in
performance.
OKINA USA Products are covered under warranty for one year from the
date of purchase. The warranty will automatically be voided if any of the
following occurs:
1. Camera sticker is removed
If the camera sticker is removed, we will not be able to confirm any
information regarding when and where the product was purchased. We
have no other way to verify the purchase record without the serial
number on the camera sticker; therefore, it should not be removed.
2.
Camera is modified in any way
If the camera is scratched, damaged, or modified in a manner not
described in this manual, the warranty will be voided immediately. It is
the customer’s responsibility to keep the camera in good condition.
3. Video or power cable is cut
The video cable and the power cable should not be tampered with.
Cutting or modifying of the cables will result in termination of the
warranty.
Model SHM-7550DN SHM-7550DNP
TV System NTSC PAL
Ima
g
e Sensor 1/3” Sony Super HAD CCD
DSP Sony HQ-1
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Synchronization Internal
V
ideo Output 1.0Vp-p Composite / 75ohms
Resolution 550 TV Lines
Minimum Illumination 0.15 Lux @ F1.0 Color mode automatically switches to
B/W mode under 2.0 Lux
Day/Night Switching Mechanical IR Cut Filter (ICR)
Auto/Manual; Color/Monochrome
Electronic Shutter
Speed 1/60~1/100,000sec 1/50~1/100,000sec
Si
g
nal to Noise Ratio More than 50dB (AGC OFF)
A
uto Electronic
Shutter ON/OFF Switchable
Back Li
g
ht
Compensation ON/OFF Switchable
Flickerless ON/OFF Switchable
A
uto Gain Control ON/OFF Switchable
Lens Not Included
Lens Mount C/CS (With Adaptor)
Lead Free Yes
Power Supply 12V DC / 24V AC
Power Consumption 3.0W / 250mA
Operation
Temperature -10°C ~ +50°C
Stora
g
e Humidity RH85% or less
Storage Temperature -20°C ~ +60°C
Dimension 60mm(W) × 50mm(H) × 119mm(L)
Wei
g
ht 400
g
CONTROL SWITCH OPERATION
CAUTION
WARRANTY
SPECIFICATION
P
A
CKAGE CON
T
ENTS