Oklahoma Sound 70 User manual

OKLAHOMA SOUND CORPORATION
Speaker Stand
INSTRUCTION MANUAL
MODEL #70
For this and other OSC products/accessories, please contact your dealer, or:
OKLAHOMA SOUND CORP
.
149 Entin Road, Clifton, NJ 07014
Tel: [phone]• Fax: [phone]
Web-Site www.oklahomasound.com • e-mail: inf[email protected]
TECHNICAL SPECIFICATIONS
Steel ........................1” x 2” — 16 Guage
Reading Surface ....Medium Oak — Standard
Also in Lt. Oak, Mahogany, Walnut or Gray
Base/Pole Color......3 Mil Powdercoat Paint in Black;
Gray Pole with Gray Reading Surface
Knob ........................Plastic with Nylon Stud
Glides ......................4 Adjustable
Edge ........................5/8” PVC T-Moulding
Dimensions ..............Reading Surface 16"H x 20"W
Height Adjustable 30”— 44”H
Weight ....................18 lbs. (Oversized Carton)
MANUFACTURER’S WARRANTY
Our Lecterns undergo the most rigid and exacting tests for superior quality
and performance before leaving the factory. Oklahoma Sound Corporation
warrants this product to be free from defective material and workmanship on
the electronic product speakers and microphones for two years from the date of
resale by an authorized Oklahoma Sound distributor. Oklahoma Sound will
replace defective parts and repair malfunctioning products under this war-
ranty when the defect occurs under normal installation and use, provided the
unit is returned to our factory via prepaid transportation after direct autho-
rization and approval by Oklahoma Sound. This warranty provides that
examination of the returned product must disclose in our judgement, a man-
ufacturing defect. This warranty does not extend to any product which has
been subject to misuse, neglect, accident, improper installation, or where the
serial number has been removed or defected and is given in lieu of any other
warranty implied or expressed and will not cover any consequential damages.

OKLAHOMA SOUND CORPORATION SPEAKER STAND: Model 70
2 3
ASSEMBLY INSTRUCTIONS
Assembly Tips
All assembly should be done on a clean protected surface, such
as carpet or the like. Assembly is easy and should take no more
than 10 minutes.
Parts
(1) Base (1) Knob
(1) Tube with 5” x 5” Plate (4) Screws
(1) Reading Top Table (4) Rectangular Tube Closures
(4) Adjustable Glides
Tools Required
Phillips-Head Screwdriver.
Assembling the Unit
1)Insert the 4 tube closures into the open ends of the 4 legs
on the base. Makesure side with nut is on the bottom.
2)Screw the 4 adjustable glides into the corresponding holes
on the bottom of the base..
3)Screw the knob into the hole near the top of the base. Do
not let the screwpartof the knob enter the tube yet, as
this will obstruct the top from going in.
4)Place the reading table face down on a protected sur-
face with the bookstop closest to you. The 4 drilled holes
will now be visible.
5)Place the tube with the 5" x 5" plate on top of the under-
side of the reading table. The 4 holes in the table will
match up to the 4 holes on the plate.The tube should be
angled towards you.
6)Screw in the 4 screws into these holes.
7)Insert the tube into the base, with the knob on the base
and the bookstop on the top, facing you.
8)Gently tighten knob for the desired height.
OPTIONAL EQUIPMENT
BRASS READING LAMP / #BRL
Attach an elegant brushed brass reading
lamp to the reading table of your new
Speaker Stand. Not only will you shed light
on the subject, but you will add pizzaz to
your new stand.
ASSEMBLY DIAGRAM