Olide 120B Technical manual

Operation Instruction
Olide-120B RF Four-channel Remote Controller
USA FCC
Part 15
Indoors
International
level
Thanks so much for your purchasing,please read the instruction
before using.
！
Safe Instruction
1
2
Overall Characteristic
3
Settng and Technical parameters
Technical parameters
Withfour-group of relay contact signal output,available to be connect with four different
access equipments.
Adopt uniformity frequency with high stability of wireless signal receiving and sending.
Operation frequency :315M, stability better than 10-5.
Remote transmitter adopts low-power consumption design with fat transmit distance.
Long-service life of battery.
DC/AC12-36V voltage input
Adopt the way of coding self-learn,convenient to add the remote transmitter.
Make your choice
Remote Transmitter
Power supply 12V 27A
Life of battery: more than 20000times.
Transmit distance:More than 25M.
Operation tempreture -42 ~45
Operation humidity 10~90%RH
Operating Freq. 315Mhz
Modulation Type ASK
Antenna Gain 0dBi
222
33

FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.