OLIMEX PWR-SWITCH User manual

PWR-SWITCH
Operation Manual
Rev.1.0 July 2020
olimex. om
1

Table of Contents
What is PWR-SWITCH.............................................................................................................................3
PWR-SWITCH Features............................................................................................................................4
How to use PWR-SWITCH?.....................................................................................................................5
Certificates.................................................................................................................................................6
Revisio History........................................................................................................................................9
2

What is PWR-SWITCH
PWR-SWTICH is optically isolated high voltage switch, which could be co trolled with small voltage
co trollers like Ardui o, ESP32, Raspberry Pi a d etc similar devices or microco trollers.
3
GREEN status LED EU style power receptable,
230VAC 16A
Co trol li e
EU style power plug

PWR-SWITCH Features
PWR-SWITCH has these features:
•EU style i put power plug
•EU style load receptacle
•I put voltage from 90 up to 230VAC
•Maximum load curre t 16A.
•Maximal load power is 3500W, resistive. Note that I ductive loads like electrical motors cause
sparkli g whe disco ected, which wear the co tacts very fast!
•Mecha ical umber of ope close operatio 10 000 000 times
•Number of Switch o /off u der full electrical load 100 000 times
•Gree LED status i dicator
•Co trol li e works with DC Voltage i ra ge 3..24VDC
•E closure Material: Fire-retarda t ABS V0
•Color: White
•Operati g Temperature: 0ºC-40ºC(32°F-104°F)
•Humidity: 5%-90%RH, No -co de si g
•Dime sio s: 88*38*23mm (L*W*H)
4

How to use PWR-SWITCH?
PWR-SWITCH have co trol li e, which has polarity:
If you wa t to drive PWR-SWITCH with Ardui o you should co ect the gree termia l with “–“ to
GND a d the termi al with “+” to Ardui o D0 pi . Here is the code to switch it o a d off:
void setup () {
pinMode (D0, OUTPUT);
}
void loop () {
digitalWrite (D0, HI H);
delay (1000);
digitalWrite (D1, LOW);
delay (10);
}
The control line will work with any voltage from 3V up to 24V DC.
5

Certificates
PWR-SWITCH has CE certificatio a d passed these sta dards tests:
CE-EMC:
•EN 55032:2015
•EN IEC 61000-3-2:2019
•EN 61000-3-3:2013 + A1:2019
•EN 55035:2017
CE-LVD:
•EN 62368-1:2014+A11:2017
All tests are made i accredited laboratory a d kept o file at Olimex Ltd.
6

7

8

Revision History
Revisio 1.0 July 2020
9