olympia electronics BS-830 User manual

4 5
940830000_09_001 940830000_09_001
Thank you for your trust in our products
Olympia Electronics - European manufacturer
NO
C
9033
82
58
78
90
Dimensional drawing (mm)
DIGITAL ELECTRONIC THERMOSTAT
ADJUSTMENT TEMPERATURE
DIFFERENTIAL
ANTI-FREEZE PROTECTION
CALIBRATION
OPERATING VOLTAGE
2 Alkaline batteries ΑΑ (LR06)
5Α (3) - 250V AC
EN 61000-6-1, EN 61000-6-3,
EN 60730-1, EN 60730-2-9
o
5 to 35 C
o
0.2 C
o
4.5 C
0 - 90% RH
2 years
90 x 90 x 33mm
ABS/PC, PC
WHITE
IP20
180gr
BS-830 BS-830/C
The device is considered an electronic device for disposal in
accordance with the European Guidelines and may not be disposed of
as domestic garbage.
ŸDispose of the device through channels provided for this purpose.
ŸComply with all local and currently applicable laws and regulations.
ŸDispose of empty batteries in designated collection points.
!
!
ANTHRACITE
o
3.0 C
+
-
WARNING HEALTH AND SAFETY INFORMATION
Disconnect the power supply prior installation of the thermostat.
National safety regulations
Risk of electric shock
Failure to comply with national safety regulations may result in
personal injury, discomfort, property damage and other potential
hazards.
ŸYou shall comply with any additional national regulatory
informations.
WARNING! installation, configuration, start-up and maintenance
must be done by qualified personnel only.
ŸComply with any national regulations and comply with
appropriate safety regulations
Olympia Electronics reserves the right to repair or to replace the returned
goods and to or not charge the buyer depending on the reason of defection.
Olympia Electronics reserves the right to charge or not the buyer the
transportation cost.
Olympia Electronics guarantees the quality, condition and operation of the
goods. The period of warranty is specified in the official catalogue of Olympia
Electronics and also in the technical leaflet, which accompanies each product.
This warranty ceases to exist if the buyer does not follow the technical
instructions included in official documents given by Olympia Electronics or if
the buyer modifies the goods provided or has any repairs or re-setting done
by a third party, unless Olympia Electronics has fully agreed to them in
writing. Products that have been damaged can be returned to the premises
of our company for repair or replacement, as long as the warranty period is
valid.
WARRANTY
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.com
[e-mail]
TECHNICAL CHARACTERISTICS
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
COLOR
TYPICAL WEIGHT (including batteries)
WARRANTY
FREE RELAY CONTACT
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
European
manufacturers

231
1
3
5
2
4
940830000_09_001 940830000_09_001 940830000_09_001
ο
If the room temperature value is 4.5 C, then the thermostat will enable the
burner, regardless of the thermostat status. This mode remains active, as long as
ο
the temperature is below 5 C.
Dispose the old batteries for recycling, in compliance with current enviromental
protection regulations.
ANTI-FREEZE PROTECTION
USING THE THERMOSTAT
ŸTo set the temperature, press any key. Decrease temperature key or Increase
temperature key. The set temperature is displayed on the screen.
The thermostat is factory calibrated, in case further calibration is required,
follow the precedure below. Remove the batteries from the device. Hold down
any key and re-install the batteries. The indication CAL and 0.0°C will displayed
in the screen. Press the decrease/increase temperature key to set the
temperature. To register the correct value, hold down the two keys until the
save indicator appears on the screen.
THERMOSTAT CALIBRATION (if required)
BATTERY REPLACEMENT
If the symbol appears on the display, then the batteries must be replaced.
Always use 2 new alkaline batteries of the same type and characteristics. Pay
attention to the correct polarity. If the thermostat does not activate, remove the
batteries and re-installed them, be sure to follow the symbols of the positive (+)
and negative (-) poles of each battery.
Do not reverse the polarity of the batteries and do not use rechargable
batteries.
Remove the protective film which is located in the right battery (Figure 2), the
thermostat is activated.
BEFORE THE INSTALLATION
ŸSwitch-on the thermostat by pressing any key.
ŸThe thermostat is deactivated by pressing the two keys simultaneously for 2
seconds. The set temperature will cease to appear while the room
temperature is displayed.
Package Contents
1 x Thermostat
2 x Alkaline batteries ΑΑ
1 x Termostat mounting base
1 x Mounting accessories
Installation
Α
Β
1.5m
ŸDo not mount the devices in recesses, shelves, behind curtains or doors,
either above or near heat sources.
ŸWall mounting with recommended height: 1.5m from the floor on an
internal wall.
ŸAvoid direct exposure to sunlight
Disconnect the power supply prior installation of the thermostat.
Risk of electric shock
Live wire (L)
230V~
To burner (L)
C
NO
Operational Information
Current
temperature
Increase
temperature key
Decrease
temperature key
Set
temperature
Low battery
indicator
Burner indication
Burner indicator
LED
Remove the
battery
protective film.