Olympus PT-044 User manual

PT-044 Instruction Manual
©2008
Printed in China
http://www.olympus.com/
VS927001
PT-044
PT-044_1-4.fm 1 ページ ２００８年９月４日 木曜日 午後７時２５分

EN 2
En
Introduction
zUnauthorized copying of this manual in part or in full, except for private
use, is prohibited. Unauthorized reproduction is strictly prohibited.
zOLYMPUS IMAGING CORP. shall not be responsible in any way for lost
profits or any claims by third parties in case of any damage occurring
from improper use of this product.
zOLYMPUS IMAGING CORP. shall not be responsible for damage, lost
profits, etc. caused by loss of image data because of defects,
disassembly, repair or modification of this product by people other than
third parties specified by OLYMPUS IMAGING CORP. or for other
reasons.
Please read the following items before use
This Case is a precision device designed for use at a water depth within
40 m. Please handle it with sufficient care.
zPlease use the Case correctly after sufficient understanding of the
contents of this manual in regard to handling of the Case, checks before
use, maintenance, and storage after use.
zOLYMPUS IMAGING CORP. shall in no way be responsible for
accidents involving immersion of a digital camera in water.
In addition, expenses incurred for damage of internal materials or loss
of recorded contents due to water entering the camera will not be
compensated.
zOLYMPUS IMAGING CORP. shall not pay any compensation for
accidents (injuries or material damage) at the time of use.
Thank you for buying the Underwater Case PT-044.
Please read this instruction manual carefully and use the product
safely and correctly. Please keep this instruction manual for
reference after reading it.
Wrong use may cause damage to the camera inside the Case due
to water leakage, and repair may not be possible.
Before use, perform an advance check as described in this manual.
The PT-044 Underwater Case is designed for FE-360/X-875/C-570.
PT-044_EN.book Page 2 Thursday, September 4, 2008 6:35 PM

EN 3
En
For safe use
This instruction manual uses various pictographs for correct use of the
product and to prevent danger to the user and other persons as well as
property damage. These pictographs and their meanings are shown
below.
WARNING
1Keep this product out of the reach of babies, infants, and children. There is
the possibility of occurrence of the following types of accidents.
• Injury by dropping onto the body from a height.
• Injury from parts of the body getting caught in parts which open and
close.
• Swallowing of small parts. Please consult a physician immediately
if any parts have been swallowed.
• Triggering of the flash in front of the eyes may cause permanent
vision impairment etc.
2Do not store with a battery in the digital camera housed in this product.
Storage with a battery inserted may lead to leakage of the battery liquid and
fire.
3If leakage of water should occur with a camera installed in this product,
quickly remove the battery from the camera. There is the possibility of
ignition and explosion from generation of hydrogen gas.
4This product is made of resin. There is the possibility that injuries may be
caused when it becomes broken because of strong impact with a rock or
other hard objects. Please handle it with sufficient care.
5The silica gel and the silicone grease for this product are not edible.
WARNING
This indicates contents for which the possibility of human
death or severe injury in case of handling under disregard
of this indication can be assumed.
CAUTION
This indicates contents for which the possibility of human
injury or the possibility of material damage in case of
handling under disregard of this indication can be
assumed.
PT-044_EN.book Page 3 Thursday, September 4, 2008 6:35 PM

EN 4
En
CAUTION
1Do not disassemble or modify this product. This may cause water leakage
or trouble. In case of disassembly or modification by persons other than
those appointed by OLYMPUS IMAGING CORP. the guarantee shall not
apply.
2Do not place this product at locations with abnormally high or abnormally
low temperatures or at locations with extreme temperature changes. The
product may deteriorate.
3Opening and closing at locations with much sand, dust, or dirt may impair
the waterproof characteristic and cause water leakage. This should be
avoided.
4This product has been designed and manufactured for use at a water depth
within 40 m. Please note that diving to a depth in excess of 40 m may cause
permanent deformation or damage to the Case and the camera inside the
Case or may lead to water leakage.
5Jumping into the water with the Case in your pocket or in your hand,
throwing the Case from a boat or ship into the water, and other rough
handling may cause water leakage. Please handle with sufficient care,
when handing it over from hand to hand etc.
6If the camera on the inside should become wet because of water leakage
etc., immediately wipe off all moisture and confirm the operation.
7Please remove the O-ring when traveling by air. Otherwise air pressure
may make it impossible to open the Case.
8For safe use of the digital camera in this product, please read the
“Instruction Manual” for the digital camera carefully.
9When sealing this product, take sufficient care that no foreign matter gets
caught at the O-ring and the contact surfaces.
Batteries
zUse only an Olympus lithium-ion rechargeable battery (LI-42B or
LI-40B) with the camera.
zTake care that the battery electrodes do not become wet. This may
cause trouble or accidents.
zCarefully read the instruction manual for the camera about other
cautions regarding batteries.
PT-044_EN.book Page 4 Thursday, September 4, 2008 6:35 PM

EN 5
En
Setting the underwater shooting scene mode
zThe FE-360/X-875/C-570 cameras incorporate several shooting scene
modes for underwater shooting, including wide-angle and macro modes.
Simply select the mode that’s most appropriate for the scene you are
shooting.
For details, see “5. Underwater Shooting According to the Scene
Type” (P.24) of this manual.
zFor details on mode setting, refer to the digital camera’s operation
manual.
For Prevention of Water Leakage Accidents
When water leakage occurs while this product is being used, repair of the
camera housed in this product may become impossible. Please observe
the following cautions for use.
1When sealing this product, make sure that no hairs, fibers, sand particles or
other foreign matter stick not only to the O-ring, but also to the contact
surface (front cover). Even a single hair or a single grain of sand may cause
water leakage. Please check with special care.
2The O-ring is a consumable part. Please replace it at least once a year with
a new one. Before each use, perform the proper maintenance.
3Deterioration of the O-ring will acelerate according to the use conditions and
the storage conditions. Immediately replace the O-ring with a new one if it
is damaged, cracked, or has lost its elasticity.
4During O-ring maintenance, clean the inside of the O-ring groove and
confirm the absence of dirt, dust, sand, and other foreign matter.
5Apply the specified silicone grease to the O-ring.
Examples of foreign matter sticking to the O-ring
Hair Fibers Grains of sand
PT-044_EN.book Page 5 Thursday, September 4, 2008 6:35 PM

EN 6
En
6The waterproof function is not effective when the O-ring is not installed
correctly. When installing the O-ring, take care that it does not project from
the groove and that it is not twisted. Also, when sealing the Case, close the
lid after confirming that the O-ring has not come out of the groove.
7This product is an airtight construction made of plastic (polycarbonate).
When it is left for a long time in a car, on a boat, at the beach, or at other
places reaching a high temperature, or when it is subjected for a long time
to uneven external force, it may be deformed and the waterproof function
may be lost. Pay sufficient attention to temperature control. Also do not
place heavy objects onto the product during storage or transport, and avoid
unreasonable storage.
8When the O-ring contact surface is pressed strongly from the outside of the
Case, or when the Case is twisted, the waterproof function may be lost.
Take care not to exert excessive force.
9
Please use the Case only after performing the advance test and the final check.
0If you should notice drops of water or other signs of water leakage while
taking pictures, ascend from the dive after performing the “safety stop” as
fast as possible considering the ascending speed and decompression time,
remove any water from the camera and the product, test according to the
item “Final check”, and confirm whether leakage has occurred or not.
Handling the Product
zUse or storage of the product at the following locations may cause
defective operation, defects, trouble, damage, fire, internal clouding, or
water leakage. This should be avoided.
• Locations reaching high temperatures such as those under direct
sunlight, in an automobile, etc.
• Locations with open fire
• Water depths in excess of 40 m
• Locations subject to vibrations
• Locations with high temperature and humidity or with severe
temperature changes
• Locations with volatile substances
zThis product is made of polycarbonate resin with excellent impact
resistance, but it may be damaged by scraping against rocks etc. It also
may break when it hits hard objects or is dropped.
zThis product is not a case to soften impacts to the camera inside the
product. When this product with a digital camera inside it is subjected to
dropping, impacts or heavy objects are placed onto it, the digital camera
may become damaged. Please handle it with sufficient care.
PT-044_EN.book Page 6 Thursday, September 4, 2008 6:35 PM

EN 7
En
zWhen the product is not used for a long time, the waterproof
performance may drop because of deterioration and growth of mold of
the O-ring etc. Before use, always perform the advance test and the final
check.
zDo not apply excessive force to the tripod seat.
zWhen a flash is used while the Case is being used, shadows may
appear at the edges of the picture. This is especially notable when
taking pictures in macro mode on the wide-angle side. Please use a
flash after image confirmation.
zDo not use the following chemicals for cleaning, corrosion prevention,
prevention of fogging, repair or other purposes. When these are used for
the Case directly or indirectly (with the chemicals in vaporized state),
they may cause cracking under high pressure or other problems.
zDo not perform operations other than specified in this instruction
manual, do not remove or modify parts other than specified, and do not
use parts other than specified.
Any troubles in taking pictures or with the equipment resulting from the
above actions shall be outside the guarantee.
zOLYMPUS IMAGING CORP. shall in no way be responsible for
accidents involving immersion of a digital camera in water.
zOLYMPUS IMAGING CORP. shall not pay any compensation for
accidents (injuries or material damage) at the time of use.
Chemicals which cannot
be used
Explanation
Volatile organic solvents,
chemical detergents
Do not clean the Case with alcohol, gasoline,
thinner or other volatile organic solvents or with
chemical detergents etc. Use pure water or
lukewarm water.
Anticorrosion agent Do not use anticorrosion agents. The metal parts
use stainless steel or brass. Wash with pure water.
Commercial defogging
agents
Do not use commercial defogging agents. Always
use the specified desiccant silica gel.
Grease other than
specified silicone grease
Use only the specified silicone grease for the silicone
O-ring, as otherwise the O-ring surface may
deteriorate and water leakage may occur.
Adhesive Do not use adhesive for repairs or other purposes.
When repair is required, please contact a dealer or
a service station of OLYMPUS IMAGING CORP.
PT-044_EN.book Page 7 Thursday, September 4, 2008 6:35 PM

EN 8
En
Contents
Introduction............................................................................ 2
Please read the following items before use........................... 2
For safe use........................................................................... 3
Batteries ................................................................................ 4
Setting the underwater shooting scene mode ....................... 5
For Prevention of Water Leakage Accidents......................... 5
Handling the Product............................................................. 6
1. Preparations...................................................................10
Check the contents of the package ..................................... 10
Names of the parts .............................................................. 11
Install the strap .................................................................... 12
Master the basic operation .................................................. 12
Holding the Case ................................................................. 12
How to Press the Shutter Button ......................................... 13
How to Switch the Shooting Mode....................................... 13
How to Use the Zoom Buttons............................................. 13
How to Use the POWER Button .......................................... 14
2. Advance Check of the Case...........................................15
Advance test before use...................................................... 15
Advance Test....................................................................... 15
3. Install the digital camera ................................................16
Check the digital camera..................................................... 16
Battery Confirmation............................................................ 16
Confirmation of the Remaining Number of Pictures to be
Taken ................................................................................ 16
Remove the hand strap from the digital camera.................. 16
Prepare the camera............................................................. 16
Applicable Digital Cameras ................................................. 16
Turn on the digital camera................................................... 16
Check the camera’s operation............................................. 17
Open the Case .................................................................... 17
Load the digital camera ....................................................... 18
Insertion of silica gel ............................................................ 18
Make sure the camera is loaded properly ........................... 19
Seal the Case...................................................................... 19
Check the operation of the loaded camera.......................... 20
PT-044_EN.book Page 8 Thursday, September 4, 2008 6:35 PM

En
EN 9
Confirm the shooting scene and shooting mode ................. 20
Mounting and removing the lens cap................................... 21
Perform the final checks ...................................................... 21
Visual Inspection ................................................................. 21
Final Test (Water Leakage Test) ......................................... 22
4. Taking Pictures Under Water.........................................23
How to use the hand strap................................................... 23
Taking pictures .................................................................... 23
Confirm the picture on the LCD monitor .............................. 23
Press the shutter button gently............................................ 23
Cautions when using the flash............................................. 23
5. Underwater Shooting According to the Scene Type ......24
Underwater shooting modes................................................ 24
kUNDERWATER WIDE1 ................................................. 24
lUNDERWATER WIDE2 ................................................. 24
HUNDERWATER MACRO ............................................... 24
How to select the shooting scene........................................ 25
Locking AF during underwater shooting .............................. 25
6. Handling After Shooting .................................................26
Wipe off any waterdrop........................................................ 26
Take out the digital camera ................................................. 27
Wash the Case with pure water........................................... 28
Dry the Case........................................................................ 28
7. Maintaining the Waterproof Function .............................29
Remove the O-ring .............................................................. 29
Removal of the O-ring ......................................................... 29
Remove any sand, dirt, etc.................................................. 30
Install the O-ring .................................................................. 31
How to Apply Grease to the O-ring...................................... 31
Replace consumable parts .................................................. 32
8. Appendix ........................................................................33
Q & A on the use of the PT-044 .......................................... 33
Specifications ...................................................................... 34
PT-044_EN.book Page 9 Thursday, September 4, 2008 6:35 PM

EN 10
En
1. Preparations
Check the contents of the package
Check that all accessories are in the box.
Contact your dealer if accessories are missing or damaged.
OLYMPUS distributor list
PT-044
(Check that the O-ring is installed.)
O-ring remover
Hand strap
Lens cap
Silica gel
Silicone grease
Instruction manual (this manual)
Case body
PT-044_EN.book Page 10 Thursday, September 4, 2008 6:35 PM