Omega ORF60X User manual

Instruction Manual for
Rangehood Models:
ORF60X
ORF90X

CONTENTS
1GENERAL
2SAFETY PRECAUTION
3WARNING
4 INSTALLATION INSTRUCTIONS
5 ATTENTION
6OPERATION
7 USE AND MAINTENANCE
8LIGHT REPLACING
9SPECIFICATIONS
It is important that you retain these instructions, proof of purchase as
well as other important documents about this product for future
reference.
Due to continual product development, Omega reserves the right to alter
specifications or appearances without notice.
Dispose of packaging responsibly – recycle where facilities are available.
1

WARNING
•Young children should be supervised to ensure that they do not play with
the appliance.
•The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervised or instruction
concerning use of the appliance by a responsible person for their safely.
•Your cooker hood is for domestic use only, not suitable for barbecue, fast -
food shops, and other commercial use.
•Any installation work should be carried out by a qualified electrician or
competent person.
•The cooker hood and its filter mesh should be cleaned regularly in order to
keep in good working order.
•Before cleaning, always ensure that you have switched your cooker hood
off.
•Do not flambé under the range hood.
•Clean the cooker hood according to the instruction manual, and keep the
cooker hood away from the danger of flames.
•If there is any fault with your cooker hood, please call the customer service
number in the Warranty Card supplied.
•Please keep the room adequately ventilated when your cooker hood and
gas hob are working.
•Do not exhaust the gas from cooker hood through the same heated flue
which is for the gas from gas hob and other kitchen appliances.
•Before installation and usage, read all the instructions and make sure that
the voltage (V) and the frequency (Hz) indicated on your cooker hood are
exactly the same as the voltage (V) and the frequency (Hz) in your home.
•To ensure that you get the best Warranty experience for your cooker hood,
please provide copies of the Warranty Card and purchase receipt, when
booking warranty work with the Customer Service department.

2
4. INSTALLATION INSTRUCTIONS
Method one:
1) The cooker hoods should be placed at a distance of 65-75cm from the cooking surface
for best effect.
2) To install onto the wall, drill 4 holes of Ø 8mm at a suitable place according with the
centre distance of hole in the back of the cooker hood.
3) Insert the nut into the holes.
4) Insert the screws into the nuts and tight.
5) Put up the cooker hood onto the fixed screws.
6) Then use the attached accessories enclosed to turn the screws into the two holes of
inside the hood, and then fix the screws to tighten the hood onto the wall.
7) Put the one way valve onto the cooker hood.

3
Method two:
1) Drill 6 holes of Ø 4mm at the bottom of the hanging cupboard.
2) Put the one way valve on the cooker hood, then install the cooker hood on the
bottom of the cupboard, tighten the hood with enclosed 6 screws.
3) Install the adjusted board on the bottom of the hood in order to keep out the gap
between hood back and cupboard.
Notice:
There are 2 methods for ventilation, including ' horizontal ventilation' and ' vertical
ventilation'. Please pay attention to the ventilation method when installation.
Horizontal ventilation:As pic. 4Ashown, please use the cover to seal the outlet on the top,
then the air can be vented from back.
Vertical ventilation: As pic 4B shown, please use the cover to seal the outlet on the back,
then the air can be vented from top.

4
6. OPERATION
Outdoor air ventilation: Turn the adjuster to outdoor position(pic.5A), install the outlet, turn
on the cooker hood, then the air will be vented from the outside outlet.
Indoor air ventilation: Turn the adjuster to indoor position (pic.5B), install the outlet cover,
turn on the cooker hood, then the air can be vented from the inside outlet.
When you choose “front re-circulation mode”, the charcoal filter must be installed.
SPEED ADJUSTMENT:
1) Push ‘Stop’ button, and the motor will stop.
2) Push the ‘Low’ button, the buzzer will buzz once, and the motor runs at low speed.
3) Push the ‘Mid’ button, the buzzer will buzz once, and the motor runs at mid speed.
4) Push the ‘High’ button, the buzzer will buzz once, and the motor runs at high speed.
5) Push the ‘Light’ button and the two lights will come on. Push it again and the light will
turn off.

5
7. MAINTENANCE
Changing and cleaning the filter as below (pic7):
1. Put the filter into the water of 40-50℃,Put some detergent in, and leave it for 2-3
minutes. Then use the soft brush to clean it with proper strength, in order not to
damage the filter.
2. The filter can be cleaned in the dishwasher. Put the filter into the dishwasher with
some detergent and run a cycle at 60℃.
All the filters are made of metal. Please do not use any corrosive detergent when
cleaning.
Notice: Please unplug before cleaning.
8. LIGHT REPLACING
1) Before changing the lights, make sure the appliance is unplugged.
2) Open the filter, see beside picture.
3) Change the Max. 40W E14 olive-shaped bulb.
4) Replace the filter to the original position.
9.SPECIFICATION
Voltage
220V-240V~/50Hz
Rotation method
Twin Motors, Twin Fans
Rated motor input power
100W+100W
Illumination ≤40W+40W(GU-10 base halogen)
Rated input power 280W
Airflow 440m
3
/hr
Outlet diameter 120mm
6