Omegon LCDStar 200x-800x LED User manual

INSTRUCTION MANUAL
LCDStar 200x-800x LED
MICROSCOPE

3. When observing the specimen, first use the low
multiplier objective lens, put the specimen in the middle
position, and then use a higher multiple objective lens. Please
fine—tune to get a clear image. When using 100X (spring, oil)
objective lens, fill the front of the objective lens with pine and
cypress oil (no bubbles) between the front of the objective
lens and the surface of the specimen. After operation, please
clean it up with xylene immediately.
4. in order to get a clear image, please adjust the lighting.
When selecting different objective lenses, adjust the variable
light bar of the condenser and the brightness of the different
lights.
5. When the light bulb needs to be replaced, please turn
off the power supply and wait for the lamp to cool before
replacing it.
Note: the joint must be fastened and the filament center must
be adjusted.
Maintenance
The microscope you buy is a precision optical instrument that
should be maintained at all times; follow the following
maintenance recommendations and your microscope will
enjoy lifelong exemption from repair.
1. After each use of the microscope, remove all specimens
from the loading table, turn off the LED light source, and pull
out the power adapter.
2. Store the microscope in a cool, dry and non-corrosive
gas environment.
3. This microscope is designed with arc handle. When
moving the microscope, please hold the "handle" of the
microscope and move it.
4. Please use clean, slightly wet cloth to clean the outer
surface of the microscope.
5. Do not use wool cloth or paper towels that are easy to
cause scraping to clean the surface of optical devices.
6. Remove fingerprints from the surface of optical devices
(glass) and use lens clearings available in photographic
equipment stores.
Cleaning agent and lens paper to wipe, do not be circular
wipe, otherwise it is easy to affect luster or cause scratches.
7. Do not privately disassemble microscopes and optical
devices.
8. When using glass carrier, you should operate carefully
to prevent being scratched by glass edge.
Reproduction of part or all of the contents of this document in any form is expressly prohibited other than for individual use only.
Subject to modifications and errors. All text, images and labels are property of nimax GmbH.
Instructions
1. Load the objective lens into the converter. In the four
holes in the hole, the total magnification of the objective lens
with different rotation multiples will be different, from low to
high. Then the specimen is placed on the platform and
positioned in the middle of the platform on the small light
transmission hole in the middle of the platform.
2. Plug in the power supply and slowly debug the light
from dark to bright. After operation, please turn the light to
the darkest and then turn off the power supply.
All pictures shown are for illustration purpose only.
Actual product may vary.
LCDStar
Instruction Manual
English
Thank you for choosing
1
2
3
4
5
6
7
8
9
What's included
Binoculars;
Objective caps;
Eyepiece caps (2x);
Strap;
Bag;
Cleaning tissue.
Figure 1. Parts description.
Parts description.
1- Display;
2- Mirror wall;
3- Moving ruler;
4- Coarse and fine focus;
5- Mobile stage;
6- Base;
7- LED light;
8 - Condenser;
9 - Double deck.