ON Semiconductor MT9M034I12STMVH-GEVB User manual
©Semiconductor Components Industries, LLC, 2016
July, 2016 −Rev. 0
1Publication Order Number:
EVBUM2437/D
MT9M034I12STMVH-GEVB
MT9M034 Evaluation Board
User's Manual
Evaluation Board Overview
The evaluation boards are designed to demonstrate the features of
ON Semiconductor’s image sensors products. This headboard is
intended to plug directly into the Demo 2X system. Test points and
jumpers on the board provide access to the clock, I/Os, and other
miscellaneous signals.
Features
•Clock Input
♦Default – 27 MHz Crystal Oscillator
♦Optional Demo 2X Controlled MClk
•Two Wire Serial Interface
♦Selectable Base Address
•Parallel Interface
•HiSPi (High Speed Serial Pixel) Interface
•ROHS Compliant
Figure 2. Block Diagram of MT9M034I12STMVH−GEVB
Block Diagram
www.onsemi.com
EVAL BOARD USER’S MANUAL
Figure 1. MT9M034 Evaluation Board
MT9M034I12STMVH−GEVB
www.onsemi.com
2
Top View
Figure 3. Top View of Evaluation Board −Default Jumpers
+1V8_VDD P5
+2V8_VDDPLL P7
MCLK_EN P19
STANDBY P12
+2V8_VAA P6
+VDDIO P4
SADDR P14
OEN_N P13
TEST P11
TRIGGER P17
FLASH P2
RESET SWITCH SW10
CLK_SELECT P20
+1V8_VDD_SLVS P21
+VDD_SLVS_SEL P22
EEPROM ADDR P15, P16
+VPP P1
ON_LED P18
+0V4_VDD_SLVS P9
+2V8_VAAPIX P8
Bottom View
Baseboard Connector J4
Baseboard Connector J3
Figure 4. Bottom View of the Evaluation Board −Connectors
HiSPi Connector J2
HiSPi Connector J1
MT9M034I12STMVH−GEVB
www.onsemi.com
3
Jumper Pin Locations
The jumpers on headboards start with Pin 1 on the leftmost
side of the pin. Grouped jumpers increase in pin size with each
jumper added.
Figure 5. Pin Locations for a Single Jumper. Pin 1 is Located at the Leftmost Side
and Increases as it Moves to the Right
Pin 1 Pins 1−4
Figure 6. Pin Locations and Assignments of Grouped Jumpers.
Pin 1 is Located at the Top-Left Corner and Increases in a Zigzag Fashion Shown in the Picture
Pins 1 and 2
Pins 3 and 4
Pins 5 and 6
Pins 7 and 8
Pins 9 and 10
Pin 1
Jumper/Header Functions & Default Positions
Table 1. JUMPERS AND HEADERS
Jumper/Header No. Jumper/Header Name Pins Description
P1 VPP Open OTPM programming voltage not supplied
P2 FLASH 1 +VDD_BUS
2 GND
3 FLASH
4 +3V3_VDD
P4 +VDDIO 2−3 (Default) Connects to on-board +VDDIO power supply
1−2External power supply connection
P5 +1V8_VDD 2−3 (Default) Connects to on-board +1V8_VDD power supply
1−2External power supply connection
P6 +2V8_VAA 2−3 (Default) Connects to on-board +2V8_VAA power supply
1−2External power supply connection
P7 +2V8_VDDPLL 2−3 (Default) Connects to on-board +2V8_VDDPLL power supply
1−2External power supply connection
P8 +2V8_VAAPIX 2−3 (Default) Connects to on-board +2V8_VAAPIX power supply
1−2External power supply connection
MT9M034I12STMVH−GEVB
www.onsemi.com
4
Table 1. JUMPERS AND HEADERS (continued)
Jumper/Header No. DescriptionPinsJumper/Header Name
P9 +0V4_VDD_SLVS 2−3 (Default) Connects to on-board +0V4_VDD_SLVS power supply
1−2External power supply connection
P11 TEST 1−2 (Default) Set to Normal Mode
2−3Set to Test Mode
P12 STANDBY 1−2 (Default) Set to Normal Mode
2−3Set to Standby Mode
P14 SADDR 1−2 (Default) I2C address set to 0x20
2−3 I2C address set to 0x30
P15, P16 EEPROM ADDR P15 Closed,
P16 Open (Default)
EEPROM Address set to 0xA8
P15 Open,
P16 Open
EEPROM Address set to 0xAC
P15 Open,
P16 Closed
EEPROM Address set to 0xA4
P15 Closed,
P16 Closed
EEPROM Address set to 0xA0
P17 TRIGGER 2 Trigger Input
P18 ON_LED 1−2 (Default) Connects to on-board LED to indicate “power on”
P19 MCLK 2−3 (Default) Demo 2X Clock Input Enable
1−2Demo 2X Clock Input Disable
P20 CLK_SELECT 2−3 (Default) Select on-board oscillator
1−2Select Demo 2X clock
P21 +1V8_VDD_SLVS 2−3 (Default) Connects to on-board +1V8_VDD_SLVS power supply
1−2External power supply connection
P22 +VDD_SLVS_SEL 2−3 (Default) Connects to on-board +VDD_SLVS_SEL power supply
1−2External power supply connection
SW10 RESET N/A When pushed, 380 ms reset signal will be sent to MT9M024
Interfacing to ON Semiconductor Demo 2X Baseboard
The ON Semiconductor Demo 2X baseboard has a
similar 26-pin connector and 13-pin connector which mate
with J3 and J4 of the headboard. The four mounting holes
secure the baseboard and the headboard with spacers and
screws.
ON Semiconductor and are trademarks of Semiconductor Components Industries, LLC dba ON Semiconductor or its subsidiaries in the United States and/or other countries.
ON Semiconductor owns the rights to a number of patents, trademarks, copyrights, trade secrets, and other intellectual property. A listing of ON Semiconductor’s product/patent
coverage may be accessed at www.onsemi.com/site/pdf/Patent−Marking.pdf. ON Semiconductor reserves the right to make changes without further notice to any products herein.
ON Semiconductor makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does ON Semiconductor assume any liability
arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation special, consequential or incidental damages.
Buyer is responsible for its products and applications using ON Semiconductor products, including compliance with all laws, regulations and safety requirements or standards,
regardless of any support or applications information provided by ON Semiconductor. “Typical” parameters which may be provided in ON Semiconductor data sheets and/or
specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer
application by customer’s technical experts. ON Semiconductor does not convey any license under its patent rights nor the rights of others. ON Semiconductor products are not
designed, intended, or authorized for use as a critical component in life support systems or any FDA Class 3 medical devices or medical devices with a same or similar classification
in a foreign jurisdiction or any devices intended for implantation in the human body. Should Buyer purchase or use ON Semiconductor products for any such unintended or unauthorized
application, Buyer shall indemnify and hold ON Semiconductor and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and
expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such
claim alleges that ON Semiconductor was negligent regarding the design or manufacture of the part. ON Semiconductor is an Equal Opportunity/Affirmative Action Employer. This
literature is subject to all applicable copyright laws and is not for resale in any manner.
PUBLICATION ORDERING INFORMATION
N. American Technical Support: 800−282−9855 Toll Free
USA/Canada
Europe, Middle East and Africa Technical Support:
Phone: 421 33 790 2910
Japan Customer Focus Center
Phone: 81−3−5817−1050
EVBUM2437/D
LITERATURE FULFILLMENT:
Literature Distribution Center for ON Semiconductor
19521 E. 32nd Pkwy, Aurora, Colorado 80011 USA
Phone: 303−675−2175 or 800−344−3860 Toll Free USA/Canada
Fax: 303−675−2176 or 800−344−3867 Toll Free USA/Canada
Email: [email protected]
ON Semiconductor Website: www.onsemi.com
Order Literature: http://www.onsemi.com/orderlit
For additional information, please contact your local
Sales Representative
Other ON Semiconductor Motherboard manuals
ON Semiconductor
ON Semiconductor NCP6925EVK User manual
ON Semiconductor
ON Semiconductor NCP571 0V9 DFN6 LDO Reference guide
ON Semiconductor
ON Semiconductor AR1331CP User manual
ON Semiconductor
ON Semiconductor MT9P017LACSTCH-GEVB User manual
ON Semiconductor
ON Semiconductor FAN3852 User manual
ON Semiconductor
ON Semiconductor NCP51705 User manual
ON Semiconductor
ON Semiconductor MT9M024IA3XTCH-GEVB User manual
ON Semiconductor
ON Semiconductor MT9M034I12STMH-GEVB User manual
ON Semiconductor
ON Semiconductor NCP1095GEVB User manual
ON Semiconductor
ON Semiconductor NCP4306 User manual
ON Semiconductor
ON Semiconductor CAT4139 User manual
ON Semiconductor
ON Semiconductor AR0134CSSM25SUEAH3-GEVB User manual
ON Semiconductor
ON Semiconductor NB7L14MMNEVB User manual
ON Semiconductor
ON Semiconductor BELASIGNA R262 BR262PMEVK User manual
ON Semiconductor
ON Semiconductor CAT4201AGEVB User manual
ON Semiconductor
ON Semiconductor AP0100AT2L00XUGAH3-GEVB User manual
ON Semiconductor
ON Semiconductor EVBUM2565/D User manual
ON Semiconductor
ON Semiconductor MT9J003 User manual
ON Semiconductor
ON Semiconductor NCV7748 User manual
ON Semiconductor
ON Semiconductor AP0202ATSL00XUGAH3-GEVB User manual
