Open Mesh S8-L Troubleshooting guide

Mode Link/Act
LAN
PoE
ResetLED Mode
PoE
Max
Fault
Power
1 5 6 7 82 3 4
Mode
Mode
S8-L
Quick Start Guide
We help professional installers and service providers create powerful, easy-to-use networks
that automatically spread Internet connections throughout hotels, apartments, retail stores,
restaurants, small and medium-sized businesses—and just about anywhere else.
The Open Mesh S Series is a plug-and-play switching solution that works seamlessly with Open
Mesh access points and CloudTrax, a free cloud-based network controller that can manage an
unlimited number of switches, access points and networks around the world.
openmesh.com
© 2017 Open Mesh, Inc. All Rights Reserved.

ModeLink/Act
LAN
PoE
ResetLED Mode
PoE
Max
Fault
Power
1 5 6 7 82 3 4
Mode
Mode
Mode Link/Act
LAN
PoE
ResetLED Mode
PoE
Max
Fault
Power
1 5 6 7 82 3 4
Mode
Mode
Switch overview
Desk or shelf mount
Apply the included rubber feet to the bottom corners of the
switch and place on a flat, level surface.
Support and resources
Visit help.cloudtrax.com for additional resources, video guides
and to contact technical support.
Physical Installation
This switch can be mounted on a desk, shelf, or wall.
Regardless of how you mount the switch, keep the following
in mind:
● Do not place heavy objects on the switch.
● The switch prefers a cool, dry environment. Don’t place
the switch in direct sunlight and ensure there are at least
two inches of space around the vents.
● Install the switch in an area free from strong
electromagnetic sources.
● Check the power cord to ensure it is fully secured to
both the switch and wall outlet.
Wall mount
Mount directly to the wall by screwing two pan head Phillips
wood screws 4.72” (12 cm) apart. Leave 3/16” (0.5 cm) of each
screw exposed. Slide the switch over the screws to secure it to
the wall. Can be mounted vertically or horizontally.
8 Gigabit PoE+ ports
Up to 30W per port
55W total PoE budget
Mode Link/Act
LAN
PoE
ResetLED Mode
PoE
Max
Fault
Power
1 5 6 7 82 3 4
Mode
Mode
Cloud Management
1. Sign up at cloudtrax.com. (It’s free and always will be.)
2. Follow the prompts to verify your account and create your
first network. If you already have a network, create a new
one by navigating to Network → Create new network.
3. Add your switch to the network by navigating to Manage →
Switches → Add New and entering the MAC address.
4. Set your configuration. Once your switch has power and
Internet, CloudTrax will configure the switch and start
reporting status within a few minutes.