Openplan EMERGE II User manual
EMERGE II
REMOTE CONTROL PAIRING GUIDE
If your remote control needs to be connected or reset for any reason,
you will need to follow the process below to pair your new remote
control unit.
Step 1. Unplug your Emerge II unit and
wait for 60 seconds.
Step 2. Remove the battery cover from
the back of your new Remote Control
Unit, and remove any plastic
covering the battery if present.
EMERGE II
PAIRING REPLACEMENT REMOTE CONTROL
Step 3. Press and hold the button inside the Remote Control Unit
behind the battery cover with a pen or paper clip as shown below until
the light on the front begins ashing blue.
Step 4. Plug in your Emerge II unit. The blue light on the front of the unit
will begin ashing as it searches for your Remote Control Unit.
Step 5. After a few seconds, the blue light should stop ashing and
your unit should be paired. If your Remote Control Unit is still not
pairing, remove then re-insert the battery and repeat the process, or call
customer support.
Reset Button
Reset Light
Table of contents
